SETUP

Network Setup of the Camera

After completing the network setup of the PC, begin the network setup of the camera. If multiple cameras are connected, it is required to set up each camera individually. The following information is necessary for the network setup of the cameras.

If you do not have the following information, refer to your network administrator or your Internet service provider. For further information about the terms, refer to page 69.

IP address

Subnet mask

Port number

Default gateway (when using a gateway server or a router)

Primary and secondary DNS server address (when using DNS)

Screenshot 1

Begin the setup when the PC is in the same condition as just after the startup.

STEP1

Start up Internet Explorer on your PC.

Screenshot 2

The browser starts up. The web page set as the home page in your browser appears.

STEP2

Enter the IP address assigned by the “Panasonic IP Setup” software in the “Address” box of Internet Explorer. (If the IP address has not been assigned yet, enter the default IP address “192.168.0.10”.)

You can confirm the assigned IP address by pressing the “REFRESH” button in the “Panasonic IP Setup” window.

If the broadband router is set to use the address translation, enter [IP address + : (colon) + port number] in the “Address” box, and press the enter key.

(The picture is the page of the Panasonic web site.)

24

Page 24
Image 24
Panasonic WV-NM100 operating instructions Network Setup of the Camera