Paradyne Hotwire 7984 manual Table A-2. DSX-1 Interface Options 2

Configuration Option Tables

Table A-2. DSX-1 Interface Options (2 of 2)

Line Coding Format

Possible Settings: AMI, B8ZS

Default Setting: B8ZS

Specifies the line coding format to be used by the DSX interface.

AMI ± Indicates the line coding format used by the DSX interface is Alternate Mark Inversion (AMI).

B8ZS ± Indicates the line coding format used by the DSX interface is B8ZS.

Line Equalization

Possible Settings: Signaling, Data

Default Setting: Signaling

Compensates for signal distortion for a DSX-1 signal over a given distance.

0±133 feet ± Provides equalization for a cable length up to 133 feet. 133±266 feet ± Provides equalization for a cable length up to 266 feet. 266±399 feet ± Provides equalization for a cable length up to 399 feet. 399±533 feet ± Provides equalization for a cable length up to 533 feet. 533±655 feet ± Provides equalization for a cable length up to 655 feet.

Send AIS on Network Failure

Possible Settings: Enable, Disable

Default Setting: Enable

Specifies the action taken on the signal transmitted to the DSX when a valid signal cannot be recovered from the network interface (LOS or cognitions OOF, AIS, or EER).

Enable ± An Alarm Indication Signal (AIS) is sent to the DSX-1 port in the event of an LOS or OOF condition on the DSX-1 interface.

Disable ± The failed signal on the interface is passed through to the DSX-1 network unchanged.

Send All Ones on Network Failure

Possible Settings: Enable, Disable

Default Setting: Enable

Specifies the action taken on the signal transmitted to the DSX when a valid signal cannot be recovered from the network interface (LOS or cognitions OOF, AIS, or EER).

Enable ± A pattern of all ones is sent to the DSX-1 port in the event of an LOS or OOF condition on the DSX-1 interface.

Disable ± The failed signal on the interface is passed through to the DSX-1 network unchanged.

Primary Clock Source

Possible Settings: DSX, Internal

Default Setting: Internal

Specifies where the unit will derive its timing from.

HPrimary Clock Source is available only when the unit is configured as an LTU. If DSL Line Rate is set lower than 1552 kbps, Primary Clock Source is forced to DSX-1 and cannot be changed.

Internal ± The clock source is derived from the internal oscillator.

DSX ± The clock source is derived from the DSX interface.

7984-A2-GB20-10 February 1999 A-5