Paradyne Hotwire 7984 1. Health and Status Messages 2 of, What Message Indicates, What To Do

Monitoring the Unit

Table 4-1. Health and Status Messages (2 of 2)

Message	What Message Indicates	What To Do
Net Margin	The signal-to-noise margin	1.	Reconfigure the unit to a higher
Threshold, Pt 1	has exceeded the		Net Margin Threshold.
	configured threshold.	2.	Contact network provider.
Primary Clock Failed	A failure has occurred in	1.	Verify that the network cable is
(DSX-1, Pt 1)	the primary clock source		securely attached at both ends.
	configured from the	2.	Contact network provider.
	Network, DSX, or from the
	card internal clock.
DeviceFailed	An internal error has been	1.	Provide the 8-digit failure code
yyyyyyyy	detected by the operating		shown ( yyyyyyyy ) to your service
	software. yyyyyyyy		representative.
	indicates the 8-digit	2.	Reset the 7984 Standalone
	hexadecimal failure code.
			Termination Unit to clear the
			condition and message.
Download Failed	A firmware download was	Repeat the download.
	interrupted.
Net Com Link Down	The Network	1.	Verify that the network cable is
	communication link is		securely attached at both ends.
	down. Communications	2.	Verify the link protocol for the
	between the management
			COM port is configured correctly.
	system and the LTU/NTU
	is not possible.

4-4 February 1999 7984-A2-GB20-10