Paxar 9403, 9402 manual

Models: 9402 9403

1 294
Download 294 pages 19.52 Kb
Page 188
Image 188

764Verifier scan error. Press Escape/Clear to clear the error and continue printing. The printer does not recalibrate after this error. Turn off the printer and then turn it back on to clear the error.

765The printhead has less than 8 bad dots (4 dots for 9403/9850 printers). The printer can shift bar code

fields to avoid bad dots. You may need to press ESCAPE/CLEAR to continue printing. Print a test label to confirm the number of bad dots.

768Printhead has more than 8 bad dots within the format area (10 dots for 9403/9850 printers) or is not connected. Make sure the printhead is connected.

770The print motor is not ready. Call Technical Support.

771The format specified by the application was not found. Reload your application and format, and try again. If the problem continues, call Technical Support.

772Verifier failure. The verifier detected three or more bad scans in a row. Press Escape/Clear to clear the error and continue printing. The printer does not recalibrate after this error.

773Verifier is enabled, but not connected. Make sure the

I/O and/or serial cable is connected to the verifier. Refer to your verifier’s Operating Instructions for more information.

790Wait until the printer is idle (no batch waiting to print or not receiving data) before you send any packets. This error may occur when you try to print a test label if the printer is busy.

791The printer has an error pending. Turn off the printer. Wait 15 seconds and turn it back on. Resend the packets. If the problem continues, call Technical Support.

792The printer is not initialized. Call Technical Support.

8-22Diagnostics and Errors

Page 188
Image 188
Paxar 9403, 9402 manual