Paxar 9403, 9402 manual Example I ,B,0,0,1,10,50,1 p

B5. supply_posn -300to 300 in 1/203 inch. 0 is the default. Adjusts the machine to print at the vertical 0,0 point on the supply. This adjustment accounts for mechanical tolerances from machine to machine. The supply position adjustment only needs to be made on the initial machine setup. Adjust the supply position if formats do not start at the 0,0 point on the supply. Increase the supply position to move print up, decrease to move print down on the label. To verify the 0,0 point, print a test label. See "Printing a Test Label" in Chapter 8 for more information.

You can not change the supply position while the printer is active. Changing the supply position will affect the print position, dispense position, and backfeed distance. Once the supply position is set, use the print control packet and backfeed control packet to adjust printing and the dispense position.

B6. cut_posn -300to 300 in 1/203 inch. Use 0 for 9403/9825. Adjusts where the tag is cut. The printer adjusts the cut position according to the black marks on the supply. You may need to adjust for aperture supplies. Increase to move the cut up, decrease to move the cut down.

B7. skip_index Skip index. The 9403 printer does not support skip index mode. Options:

0Disable skip index mode (default)

1Enable skip mode. Allows the printer to skip a sense mark and print an image over multiple labels.

Example {I ,B,0,0,1,10,50,1 p }

Indicates black mark and thermal direct stock has been loaded, causes the printer to operate in on-demand mode, feeds the supply approximately .05 inches up before printing the format on each label (10/203 inches), feeds the supply .25 inches (50/203 inches) before cutting, and enables skip index mode.

2-12Configuring the Printer