Paxar 9403, 9402 manual T t i n g C o m m u n i c a t i o n P a r a m e t e r s

Models: 9402 9403

1 294
Download 294 pages 19.52 Kb
Page 22
Image 22

S e t t i n g C o m m u n i c a t i o n P a r a m e t e r s

Use the following information if you are using serial communications. See "Using Parallel Communications" for information about parallel communications.

Not all printers have a parallel port.

The communication parameters at the printer must match those at the host, or you will not be able to communicate.

You can use the communication settings packet to set communication parameters for your printer.

On MS-DOS computers, you can use the MODE command to set communication values on your PC.

For example

MODE COM1:9600,N,8,1

This command sets your host to these communication values: 9600 baud, no parity, an 8 bit word length, 1 stop bit.

U s i n g P a r a l l e l C o m m u n i c a t i o n s

If your printer supports parallel communications, the parallel port is IEEE-1284 or Centronics® mode. You can set which mode to use through the control panel. Refer to the Quick Reference or Operator’s Handbook for control panel information. The communication settings are automatically configured for you. There are no operator settings required.

We recommend waiting at least two seconds (or longer) when switching between the serial and parallel ports to send data, because data may be lost. Be careful when using print spoolers, because data transmission occurs in the background of the operating system. This makes data transmission completion difficult to determine when switching between ports.

2-2Configuring the Printer

Page 22
Image 22
Paxar 9403 T t i n g C o m m u n i c a t i o n P a r a m e t e r s, I n g P a r a l l e l C o m m u n i c a t i o n s