Paxar 9403, 9402 manual Action,dispos,bkfddis p, 2 p

Syntax	{I ,G,action,dis_pos,bkfd_dis p }
G1. G	Backfeed Control Packet
G2. action	Action. Options:
	0	disable backfeed (default)
	1	enable backfeed (use on any printer without a knife)
	2	enable extended backfeed (use on any printer with
		a knife)
G3. dis_pos	Dispense Position. Adjusts the stopping point of the label. 50
	to 200 dots (default 65 dots). Use 95 dots for the printer
	applicator.
G4. bkfd_dis	Backfeed Distance. Amount to move label backwards. 10 to
	200 dots (default 65 dots). Use 95 dots for the printer
	applicator. This distance can not be greater than the
	dispense position.
	The backfeed distance should equal the dispense position.
	An exception is if you are tearing instead of peeling. Then,
	the backfeed distance must be 30 dots (.150 inches) less than
	the dispense position. However, you will have a 30 dot
	non-print zone on your supply. The 30-dot difference
	accounts for improper tearing of butt cut supplies, because
	you do not want any exposed adhesive under the printhead.
Example	{I ,G,2 p }

Enables extended backfeed and cuts any tags remaining between the knife and printhead and moves the supply backwards so the next tag is underneath the printhead. Using cut mode 4, you do not have to press FEED (FEED/CUT) to cut the last tag.

Example {I ,G,1,50,10 p }

Enables backfeed and sets the dispense position to 0.25 inches (50/203) and the backfeed distance to 0.05 inches (10/203).

2-20Configuring the Printer