CONFIGURING PRESET TOURS

A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX8100 Series DVR can store up to four preset tours. While four tours can be programmed, only one tour can be activated at a time. A preset tour will operate continuously until another PTZ control action is performed. At least one PTZ preset must be set in order to create a preset tour.

This section describes how to configure preset tours and includes the following topics:

Programming a Preset Tour

Activating a Preset Tour

Deactivating a Preset Tour

PROGRAMMING A PRESET TOUR

This section describes how to program a preset tour and includes the following topics:

Accessing a Preset Tour Group

Adding Presets to a Tour

Deleting Presets from a Tour

Accessing a Preset Tour Group

To access the “Preset tour group” dialog box:

1.On the DX8100 toolbar, click .

2.On the DX8100 keypad, click and then on the PTZ keypad. The “Preset tour group” dialog box opens.

3.Select the preset tour (1-4) that you want to program from the drop-down box.

4.Do one of the following:

To add presets to a tour, refer to Adding Presets to a Tour.

To delete presets from a tour, refer to Deleting Presets from a Tour.

￿

Figure 46. Preset Tour Dialog Box

C2631M-A (6/07)

Client Application

65

Page 65
Image 65
Pelco C2631M-A manual Configuring Preset Tours, Programming a Preset Tour, Accessing a Preset Tour Group