Pelco CM6800E-48X8 manual KBD100, KBD200A, and KBD300A Series Keyboards

KBD100, KBD200A, AND KBD300A SERIES KEYBOARDS

You can connect up to eight KBD100/200A/300A Series keyboards to any of the following ports:

•COM 5 (1 direct-powered keyboard or up to 8 remotely connected keyboards)

•COM 6 (1 direct-powered keyboard or up to 8 remotely connected keyboards)

•COM 7 (up to 8 remotely connected keyboards)

•COM 8 (up to 8 remotely connected keyboards)

The total number of KBD100/200A/300A Series keyboards connected to the CM6800E cannot exceed 16.

KBD100, KBD200A, and KBD300A: Direct-Powered Keyboards

Use COM 5 and 6 (Serial Ports 5 and 6) for direct-powered local keyboards. Each port can power one KBD100/200A/300A Series keyboard.

If you are connecting more than one keyboard to COM 5 or 6, a KBDKIT(-X) is required for each keyboard. Refer to the KBD100, KBD200A, and KBD300A: Remote Keyboards section.

1.Using the 25-foot (7.62 m) straight data cable supplied with the keyboard, plug one end into the RJ-45 connector on the rear of the keyboard.

NOTE: If distance between CM6800E and keyboard exceeds 25 feet, use KBDKIT(-X).

DEFAULT (ADDRESS 0) DIP SWITCH SETTINGS (SHIPPED FROM FACTORY)

DIP SWITCHES 1-8 OFF

KBD300A

Figure 14. Data Cable Plugged into Local Keyboard

2.Plug the other end of the data cable into either COM 5 or 6 on the CM6800E.

KBD100, KBD200A, KBD300A KBD100, KBD200A, KBD300A

1

2

31 32 3

	4	4
7	8

010101

5

6

7

8

1 2 3 4 5 6 7 8

		CONTROL
A T	T	R R	T	T	R R B
+	-	- +	+	-	-	+
					F
	1		2		3

1

CM6800E-48X8		KBD100, 200A, 300A
COM 5&6		RJ-45 PIN-OUTS
1	Rx+		1	Tx+
2	Rx-		2	Tx-
3	KBD 12V	3		12V
4	KBD GROUND	4		12V
5	GROUND		5	GROUND
6	NC	6		NC
7	Tx-		7	Rx-
8	Tx+		8	Rx+

120/230~ 50/60 HZ 25 WATTS

Figure 15. Data Cables Plugged into COM 5 and 6

22 C1528M-F (6/05)