Pelco CM6800E-48X8 manual Event Timers

EVENT TIMERS

You can automate system operation to activate sequences or macros on specific monitors. Events can be scheduled on a daily or weekly basis, or on a specific date such as a holiday. If you set more than one timer to start at the same time, the timers will run in the following order of precedence: weekly, special, daily.

On each event timer screen:

•Two methods are provided for selecting the event time: scrolling through time values or entering a valid hour and minute.

•Each timer can activate either a macro or a sequence. Select a value for either the MACRO field or the SEQ field.

•A macro started by an event timer runs until the last step is completed (unless you specify a loop in the macro).

•A sequence started by an event timer runs continuously until another sequence or macro begins, or until a system operator selects a different camera.

PELCO SWITCHER			EVENT TIMER	DAILY TIMER 01
	MODEL CM6800E	1	DAILY TIMER	ENABLE:	OFF
	MAIN MENU
1	CAMERA	2	WEEKLY TIMER	TIME:	12:02
2	LOGICAL CAMERA	3	SPECIAL TIMER	MACRO	00
3	MONITOR
4	ACCESS		RETURN	MON	SEQ
5	TIME & DATE
6	PORT			1	00
7	PRIORITY			2	00
8	SEQUENCE			3	00
9	MACRO			4	00
10	ALARM CONTACTS
				5	00
11	EVENT TIMER
12	SET AUXILIARY			6	00
13	SET PASSWORD			7	00
14	SYSTEM			8	00
15	ABOUT CM6800E
	ENGLISH			RETURN
	RETURN

Figure 41. Sample Event Timer Programming

1.Select the timer number.

2.Select ON in the ENABLE field.

3.Set the hour and minute at which the event is to begin (24-hour time) in the TIME field.

4.Special timers only: select the date on which the event is to begin (DD-MMM-YY).

5.Select the event to be activated by the event timer.

To select a macro, select a macro number. For a weekly timer specify the macro in the column under the desired day of the week.

To select a sequence, select a sequence number to run on a specific monitor. For a weekly timer specify the sequence in the column under the desired day of the week

54 C1528M-F (6/05)