Pelco CM6800E-48X8 manual Configure the CM6800E AS a Satellite Device, Satellite Monitor Access

CONFIGURE THE CM6800E AS A SATELLITE DEVICE

In addition to any programming needed for the devices connected to the CM6800E-48X8 (such as camera control and monitor settings), you must configure the following CM6800E satellite settings.

•Monitor Access: Change the appropriate monitor access to TIE LINE

•Port: Change the Port 7 device setting to SATELLITE

•Alarms (optional): Enable the appropriate internal and external alarm contacts, and then set them to report to the CM740/CM9760 system.

Satellite programming instructions are provided in the following sections. Refer to the Programming section for basic CM6800E programming instructions.

Once the CM6800E programming is complete, then you must configure the CM6800E-48X8 as a satellite device within the 9700 System configuration files. If you are using the CM9700-MGR System Manager software, refer to the Configure CM9700-MGR System Manager Settings section. If you are using the CM9760-MGR System Manager software, refer to the Configure CM9760-MGR System Manager Settings section.

Satellite Monitor Access

Change the setting to TIE LINE for each monitor output connected to the 9700 System matrix bay, as shown below. Note that you must use the CM6800E-48X8 monitor outputs in sequential order, starting with monitor output 1.

NOTE: You cannot change the access setting of the monitor you are currently viewing.

PELCO SWITCHER
	MODEL CM6800E			SATELLITE VIEW
	MAIN MENU		ACCESS
1	CAMERA
2	LOGICAL CAMERA			MON	VIEW
3	MONITOR	1	KEYBOARD TO MONITOR
4	ACCESS			1	TIE LINES
		2	CAMERA TO KEYBOARD
5	TIME & DATE			2	TIE LINES
6	PORT	3	CAMERA TO MONITOR
				3	TIE LINES
7	PRIORITY	4	SATELLITE VIEW
				4	TIE LINES
8	SEQUENCE
9	MACRO		RETURN	5	TIE LINES
10	ALARM CONTACTS			6	TIE LINES
11	EVENT TIMER
				7	TIE LINES
12	SET AUXILIARY
13	SET PASSWORD			8	LOCAL
14	SYSTEM
15	ABOUT CM6800E				RETURN

ENGLISH

RETURN

Figure 54. Set Satellite Access

80 C1528M-F (6/05)