Pelco CM6800E-48X8 manual Desired Action Command Result, Uppercase characters

Table J. ASCII Commands

Number ranges are enclosed in brackets – do not enter the brackets. When you control a fixed speed pan and tilt, omit the speed information.

NOTE: In a 96 x 16 system the numbers for cameras, monitors, alarms, and relays can be doubled.

Desired Action	Command	Result
Select monitor	[1-9999]Ma	Calls a monitor to use for camera operation.
Select camera	[1-9999]#a	Selects a camera to display on the current operating monitor. The NEXT key (+) and
Next camera	+a	PREV key (-) commands switch to the next numbered camera in the system.
Previous camera	-a
Start a sequence forward	[1-99]qa	Starts the selected sequence going forward (incrementing camera numbers).
Start a sequence backward	[1-99]ba	Starts the selected sequence going backward (decrementing camera numbers).
Hold a sequence	ea	Places the running sequence on hold, freezing the currently selected camera on the
		monitor. It lets you control the camera or switch. The sequence is still “armed” on
		the monitor, but inactive.
Hold a macro	[1-64]ea	Places the running macro on hold.
Pan left	[1-64]La	Moves the currently selected pan and tilt device left or right at the speed
Pan right	[1-64]Ra	indicated. If you omit the speed, some devices move at their default speed and
Stop pan left	~La	others move at their slowest possible speed. Speed information has no effect on
Stop pan right	~Ra	fixed speed devices.
Tilt up	[1-63]Ua	Moves the currently selected pan and tilt device up or down at the speed
Tilt down	[1-63]Da	indicated. If you omit the speed, some devices move at their default speed and
Stop tilt up	~Ua	others move at their slowest possible speed. Speed information has no effect on
Stop tilt down	~Da	fixed speed devices.
Zoom telephoto	Ta	Makes the currently selected camera zoom in (close up view) or zoom out (wide
Zoom wide	Wa	view).
Stop zoom telephoto	~Ta
Stop zoom wide	~Wa
Focus near	Na	Changes the good focus range nearer or farther on the currently selected camera.
Focus far	Fa
Stop focus near	~Na
Stop focus far	~Fa
Iris open	Oa	Opens (brighter image) or closes (darker image) the iris on the currently selected
Iris close	Ca	camera.
Stop iris open	~Oa
Stop iris close	~Ca
Stop all PTZ motion	sa	Stops all image motion (stops pan, tilt, zoom, focus, and iris). Does not stop a
		pattern.
Record pattern	[1-99]/a	On receivers that do patterns, these commands let you record your motions and
Execute pattern	[1-99]pa	operations (for a limited time) and then have the system repeat them.
End pattern	[1-99]na
Go to preset position	[1-99]\a	Recalls a stored preset position.
Set preset with a label	la[string]!a	Sets a preset location with an embedded label, where the ASCII string must be
	[1-9999]^a	UPPERCASE characters.
		The [string] is an alphanumeric label up to 20 characters long and [1-9999]is the
		associated preset number.
		NOTE: All transmitted characters must be ASCII.
Set preset without a label	[1-9999]-^a	Sets a preset location without an embedded label.
Begin zone	[1-8](a	Begins a zone without a label.
Begin zone with a label	la[string]!a[1-8](a	Begins a zone with an embedded label. The ASCII string must be uppercase
		characters.
		(Continued on next page)

92 C1528M-F (6/05)