Pelco CM6800E-48X8 manual System START-UP, POWER-UP the System, Initialize Keyboards

SYSTEM START-UP

After completing the system installation, follow the procedure below to start proper system operation. Skip any “system-specific” steps that do not apply to your system setup.

POWER-UP THE SYSTEM

Plug the CM6800E power cord into a 120/230V, 50/60 Hz power source. Plug in and turn on all devices connected to the CM6800E. Once the system is powered-up you will see video from camera 1 and the following time/date stamp on all system monitors:

Figure 29. CM6800E Time/Date Stamp on Monitor

The time stamp will be advancing in one-second increments. Wait five seconds before proceeding.

INITIALIZE KEYBOARDS

Specify a monitor for each keyboard after your first power-up or any time power is cycled to the keyboard or the CM6800E. Always allow five seconds to elapse before specifying a monitor.

1.Enter a number corresponding to the monitor output that is feeding the monitor you are viewing.

2.Press the MON key. The keyboard LED displays the number you entered. This also confirms successful communication between the keyboard and the CM6800E. If the keyboard LED does not display the monitor number, repeat 1 and 2.

36 C1528M-F (6/05)