Pelco CM6800E-48X8 manual Connecting a Single ALM2064 Alarm Interface Unit

Connecting a Single ALM2064 Alarm Interface Unit

To connect a single ALM2064 Alarm Interface Unit:

1.Connect the ALM2064 OUT port to COM 3 on the CM6800E using the 6-foot (1.8 m) straight data cable supplied with the CM6800E.

2.Set SW2, DIP switches 1-8 to the appropriate positions for the local address (default address setting is 1). Refer to the ALM2064 Alarm Interface Unit Installation/Operation Manual for instructions.

			010101
		1	5
		2	6
31	32	3	7
3	4	4	8
7	8

1 2 3 4 5 6 7 8

		CONTROL
A T	T	R R	T	T	R R B
+	-	- +	+	-	- +
					F
	1		2		3
1
					120/230~
					50/60 HZ
					25 WATTS

CM6800E-48X8 COM 3 DEFAULT SETTINGS: M, RS-485, 19200 BAUD,

NO PARITY, 8 DATA BITS, 1 STOP BIT

CM6800 COM 3		ALM2064		CM6800 COM 3	STRAIGHT CABLE
					(SUPPLIED)
RJ-45 PIN-OUTS		RJ-45 PIN-OUTS		RJ-45 PIN-OUTS
1	Rx+	1	Tx+	ALM2064	RS-485
2	Rx-	2	Tx-
3	NC	3
4	NC	4
5	GROUND	5
6	NC	6	Rx-
7	Tx-	7
8	Tx+	8	Rx+		CONNECT THROUGH

THE "OUT"PORT

Figure 19. Connecting a Single ALM2064 Alarm Interface Unit

C1528M-F (6/05) 27