Pelco CM6800E-48X8 manual Program Cameras

PROGRAM CAMERAS

PELCO SWITCHER
	MODEL CM6800E	CAMERA 0001
	MAIN MENU
1	CAMERA	VERTICAL DRIVE: OFF
2	LOGICAL CAMERA
3	MONITOR	CONTROL:	EXT COAX
4	ACCESS	PORT ADDRESS:	01
5	TIME & DATE
6	PORT	CAMERA TITLE
7	PRIORITY
8	SEQUENCE
9	MACRO	CAM 1
10	ALARM CONTACTS
11	EVENT TIMER	SELECT CHARACTER
12	SET AUXILIARY
13	SET PASSWORD
14	SYSTEM	RETURN
15	ABOUT CM6800E

ENGLISH

RETURN

Figure 40. Program Cameras

1.In the CAMERA field, select the logical camera number of the video input to be defined.

2.In the CONTROL field, select the receiver control type.

EXT COAX: Coaxitron extended mode (32-bit)

STD COAX: Coaxitron standard mode (15-bit)

MUX: Genex multiplexer

PTZ-A: RS-422 Control Port A

PTZ-B: RS-422 Control Port B

M-02: Reserved for future use

M-08: Reserved for future use

NOTE: If you select PTZ-A or PTZ-B you must also program Serial Port 9 or 10 (refer to Ports in this section). A 96 x 16 System includes PTZ-C and PTZ-D (Serial Ports 11 and 12).

3.The PORT ADDRESS field is required for Genex or RS-422 control only.

Genex multiplexer: Select the address of the multiplexer (01-32); this address must match the unit ID specified through multiplexer programming. Refer to the MX4000 Genex Series Simplex and Duplex Multiplexers Installation/Operation Manual.

RS-422 cameras: Select the camera/device address for RS-422 control (01-32). The port address must match the address setting configured through the camera/receiver DIP switch settings.

52 C1528M-F (6/05)