General installation procedure for SCO OpenServer
The general procedure for installing and configuring host cards, drivers software and associated utilities for the SCO OpenServer operating system is as follows:
1.Install any UltraPort, UltraPort SI, and UltraPort Express cards you require into your system. See Installing host cards and cable accessories on page 94
2.Install the SPEED SCO OpenServer drivers and utilities onto your system using the procedures described in Installing device drivers and utilities on page 46.
3.If required, remove any host cards you want from your system. See Removing host cards on page 100.
4.Using the Port Configuration tool, configure the serial ports you have added to the system. See Configuring serial ports on page 52.
Your system can now use the serial adaptor cards you have installed. If required, you can reconfigure serial ports following initial installation.
UltraPort Serial Adaptors User Guide | Chapter 2 Installing drivers and host cards |
Installing under SCO OpenServer and OpenServer6 | Page 45 |
|
