Perle Systems 5500152-23 manual Installing drivers and utilities

Installing drivers and utilities

To install the SPEED device drivers and utilities for the SCO UnixWare operating system proceed as follows:

1.Login to your system as root.

2.Load the CDROM into your system CD drive.

3.Mount the CDROM to a mount point, for example /cdrom.

4.At the command prompt, type:

pkgadd -d /cdrom/drivers/ultraport/unixware/x.y.z/spd-uw-x.y.z.pkg spd , where x.y.z is the version number of the driver.

5.Press the Enter key.

The system now installs the driver and displays a series of messages ending with a successful installation message.

Upon installation of the drivers, your UltraPort cards are ready to use.

Note

A re-boot of your system is not necessary as the drivers for your UltraPort card are dynamically loadable and will be loaded as soon as any software attempts to access the associated devices.

UltraPort Serial Adaptors User Guide	Chapter 2 Installing drivers and host cards
Installing under SCO UnixWare	Page 64