Philips DVDR 80 BConnecting the DVD Recorder, Preparing the remote control for operation, Tip

BConnecting the DVD Recorder

Preparing the remote control for operation

The remote control and its batteries are packed separately in the original DVD Recorder packaging. You must install the batteries in the remote control - as described in the paragraph below - before use.

1Take the remote control and the enclosed batteries (2 AA batteries).

2Remove the battery compartment lid, insert the batteries, then replace the battery compartment lid. Always install the +/- ends

of the batteries as indicated inside the battery compartment.

The remote control is now ready to use.

Its range is approximately 16-32 feet (5 to 10 meters).

'Correct aiming' of the remote control
In the following sections, you require the remote control for the first
time. When using the remote control, always aim the front part of it at	Tip
the DVD Recorder, not the TV.

Connecting your DVD Recorder to the TV

The necessary cable connections must be made before you can record or playback TV programs using your DVD Recorder.

Connect the DVD Recorder directly to the TV. Connecting a video cassette Recorder between the DVD Recorder and the TV could result in poor picture quality.

When you install your DVD Recorder for the first time, select one of the following options:

'Connecting with Component Video (Y Pb Pr, YUV) / Progressive Scan (Y Pb Pr)

If your TV is equipped with Component Video (Y Pb Pr, YUV) / Progressive Scan (Y Pb Pr) input

'Connecting with S (Y/C)'

If your TV is equipped with a S-Video (SVHS) jack.

'Connecting with a Video (CVBS) cable'

If your TV is equipped with a Video (CVBS) jack.

'Connecting only with the antenna cable'

If your TV has only an Antenna-In jack (no other audio and video in jacks) or you do not wish to use any other cable. The TV's Antenna In jack may be labeled ANT IN, RF IN, 75 ohm, etc. Check your TV instructions for details.

ENGLISH

Connecting the DVD Recorder 11