5Connect the mains jack 4MAINS at the back of the DVD Recorder with the power supply using the supplied power cable.

The most important features of the DVD Recorder will appear on the display.

After the initial installation is completed, this function will be switched off. How you switch on this function again, read in the chapter 'User preferences' in the section 'Standby'.

6

Press STANDBY-ONm on the recorder. '￿￿ ￿￿ ￿￿￿' will

appear on the display.

7Switch on your TV and select the channel used for DVD/VCR playback on your TV. Choose between channel 3 or 4.

How do I switch the Recorder between channel 3 and 4?

The factory setting is for channel 3. However, if you would like to switch to channel 4, proceed as follows:

1Hold 4 on the remote control while '￿￿ ￿￿ ￿￿￿' is displayed.

2 '￿￿￿' (channel 4) will appear on the display.

3 If you want to switch back to channel 3, hold 3 . '￿￿￿' (channel 3) will appear on the display.

4 After the installation you can switch between the channels only

during standby.

?

8Switch your TV to the selected channel (channel 3 or 4). Use therefore your TV remote control.

The menu for language selection will appear on the screen.

aI don't see a menu for language selection

 

b Check the cable connections.

Problem

b Change between channel 3 and 4 on the TV.

9This TV channel number must be used in the future for DVD Recorder playback.

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.

Initial Setup

Menu Language

English

Español

Français

Press OK to continue

18

Connecting the DVD Recorder

 

Page 30
Image 30
Philips DVDR 80 Problem, How do I switch the Recorder between channel 3 and 4?, AI dont see a menu for language selection