Philips DVDR 80 manual Connecting only with the antenna cable

7Connect the mains jack 4MAINS at the back of the DVD Recorder with the power supply using the supplied power cable.

The most important features of the DVD Recorder will appear on the display.

After the initial installation is completed, this function will be switched off. How you switch on this function again, read in the chapter 'User preferences' in the section 'Standby'.

8	Press STANDBY-ONm on the recorder. '￿￿ ￿￿ ￿￿￿' will
	appear on the display.

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.

Connecting only with the antenna cable

USE THIS CONNECTION IF YOUR TV ONLY HAS A SINGLE ANTENNA IN JACK AND DOES NOT HAVE ANY AUDIO/VIDEO JACKS. Please observe that you must adjust the TV to the DVD-Recorder (channel 3 or 4).

Have the following cables ready:

an antenna cable (1, supplied), and a power cable (2, supplied).

1Switch off your TV.

2Remove the antenna or Cable TV signal from the antenna input jack of the TV. Insert it into the ANTENNA IN jack at the back

of the DVD Recorder.

3Insert one end of the supplied antenna cable into the TV OUT jack at the back of the DVD Recorder and the other end

into the antenna input jack at the back of the TV.

4Demo Pin

Your DVD-Recorder is equipped with a Retail Demo Pin inserted in the G-LINKjack at the back . On the retail floor with the Demo Pin inserted, the demo about the GUIDE Plus+® system is automatically activated after the automatic channel search. Remove the Demo Pin to disable the Retail Demo feature.

ENGLISH

Connecting the DVD Recorder 17