Philips DVDR 80 Connecting with a S Y/C cable, Switching TV and DVD Recorder to Progressive scan

Switching TV and DVD Recorder to 'Progressive scan'

The factory settings of the DVD Recorder are set to 'Interlaced'. If you selected the 'Progressive scan' connection during installation, you must switch the 'Component Video output' of the DVD Recorder and, if necessary, the 'Component Video input' of the TV to 'Progressive scan'.

Switching the TV

Please select 'Progressive scan' for the Component Video input on the TV. If necessary, see your TV instruction manual.

If your TV is equipped with separate input jacks for Interlaced and Progressive, connect the DVD Recorder to the jack that supports 'Progressive scan'.

Switching the DVD Recorder

1Disconnect the recorder's power cord.

2Hold down O on the DVD Recorder while reconnecting the power cord. 'PRO' (progressive scan) will appear on the display.

3If you want to switch back, repeat steps 1 and 2 . 'PRO'

(progressive scan) will	disappear from the display. The DVD	Tip
Recorder is switched to	'Interlaced.'

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.

Connecting with a S (Y/C) cable

This connecting cable, also known as the SVHS cable, is used to transmit the brightness signal (Y signal) and color signal (C signal) separately. This mini DIN jack/plug is also called a Hosiden jack/plug.

Have the following cables ready:

an antenna cable (1, supplied), a power cable (2, supplied), a S-video (SVHS) cable (3), an audio cable (4, with red/white ends).

1

2

Remove the antenna or cable TV signal from your TV. Insert it into the ANTENNA IN jack at the back of the DVD Recorder.

Insert one end of the supplied antenna cable into the TV OUT jack at the back of the DVD Recorder and the other end into the antenna input jack at the back of the TV.

14 Connecting the DVD Recorder