Cleaning
If lines appear on the printed pages or on the fax transmissions or documents are not properly fed, you should clean the scanner.
Switch the device off and disconnect from the power supply before you clean it.
CAUTION!
Switching off the device!Turn the device off using the on/off switch on the back before you remove the plug from the socket.
CAUTION!
Recommissioning!Plug the power cable into the electrical outlet. Only after switch the device on using the on/ off switch on the rear.
DANGER!
Instructions for Cleaning!Use a soft,
Moisten the cloth slightly with cleaning alcohol in order to remove stubborn marks. The cloth must however, never be wet.
Cleaning the Scanner
1Open the scanner cover.
2Carefully wipe the scanner glass of the flatbed scan- ner with a
EN
3Close the scanner cover.
Calibrating the Scanner
If vertical lines appear on the printed pages or on the fax messages, it is possible the scanner needs to be cali- brated.
CAUTION!
Instructions for Calibrating!The scanner is calibrated in the factory and normally no new calibration is needed. Do not use this function frequently. Clean the the scanner glass and the scanner film first before calibrating the scanner (see also chapter Cleaning, page 73).
1Insert a white piece of paper onto the flatbed scanner.
Service · Cleaning | 73 |