Pioneer CDJ-200 manual Other Troubleshooting, English Français

OTHER (TROUBLESHOOTING)

TROUBLESHOOTING

Incorrect operations can be mistaken as malfunctions. If you believe the unit is not operating correctly, consult the chart below. Sometimes incorrect operation may be due to a malfunction in another component. If the problem is not fixed, check the other components used with the player. If the problem still persists, contact your nearest Pioneer authorized service center or dealer for service.

Symptom	Cause		Remedy
Disc doesn’t eject even when EJECT	÷ Power plug is disconnected from outlet.	÷ Connect plug to wall outlet.
button (0) is pressed.
Play doesn’t commence even when	÷ The auto cue function is set to on.	÷ Press the AUTO CUE button to turn off the
the disc is inserted.			Auto Cue function.
Playback immediately stops when	÷ Smudges on the disc, etc.	÷ Clean the smudges from the disc and then
started. During playback, the player			play it again.
pauses or stops.
No sound is audible.	÷ Output cables are connected incorrectly or	÷ Recheck connections. Refer to installation
	are loose.		instructions.
	÷ Incorrect operation of DJ mixer.	÷ Check the settings of the DJ mixer switches
			and sound volume controls.
	÷ Pin plugs and/or amplifier terminals are	÷	Clean away dirt.
	dirty.
	÷ Player is in pause mode.	÷ Press the PLAY/PAUSE button (6).
Cannot playback MP3s.	÷ The files are in the wrong format.	÷ Refer to P.6 “PLAYING MP3 FILES.”
Sound is distorted, noise is output.	÷ Incorrect connections.	÷ Connect to audio mixer's LINE INPUT termi-
			nals. (Do not connect to MIC terminals.)
	÷ Pin plugs and/or amplifier terminals are	÷	Clean away dirt.
	dirty.
	÷ Interference is being picked up from a TV	÷ Switch OFF TV set, move player away from TV
	set.		set or plug the player into a separate outlet.
With certain discs, loud noise is	÷ Disc has a bad scratch or warp.	÷	Replace disc.
produced or play stops.	÷ Disc is extremely dirty.	÷	Clean disc.
When the auto cue function is set	÷ If the sound muted portion between	÷ Press the AUTO CUE button to turn off the
ON, track search is not finished.	selections is long, searching time will be		Auto Cue function.
	long.
Back cue function cannot be carried	÷ The cue point is not set yet.	÷	Set the cue point. (See page 24.)
out even though the CUE button is	÷ The cue point is set to an MP3 file in a	÷ During playback of MP3s, back cue is possible
pressed in playback mode.	different folder.		only within the same folder.
Pressing the OUT/OUT ADJUST	÷ No cue points (loop-in points) have been set.	÷ Set a cue point.
button does not start loop play.	÷ The OUT/OUT ADJUST button was	÷ During playback of MP3s, looping is possible
	pressed during the playback of an MP3 file		only within the same track that has a cue point
	other than the one with the cue point (loop-		(loop-in point) set.
	in point) set.
Cannot search MP3s.	÷ Attempted to search (fast-forward/fast-	÷ Searching with MP3s are only possible within
	reverse) MP3s into a different folder.		the same folder.
The picture of the TV screen is	÷ Interference is being picked up from the CD	÷ Turn off POWER switch of the player, or move
fluctuated or FM broadcast is	player.		the player away from the TV or tuner.
interfered with noise.
The disc is not rotating when power	÷ The disc rotation stops automatically if no	÷ Playback can be started from the first track by
is ON.	operation has been performed for 100		pressing the PLAY/PAUSE button (6). Press
	minutes or more in pause mode.		the EJECT button (0) to eject the disc.
	÷ When the last track on the disc is over the
	disc stops rotating.

÷Static electricity and other external effects may cause this unit to malfunction. In this case, set the POWER switch to OFF, then switch it on again after the disc has come to a complete stop.

÷This unit cannot playback unfinalized (partial discs) CD-R or CD-RW discs.

÷This component is designed to play 12 cm discs and 8 cm discs with a commercially available adaptor, eccentrically shaped discs cannot be played since damage or malfunction may result.

÷The BPM value measured by the CDJ-200 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result of differences in the BPM value measurement method; not a result of a fault with the player.

÷When playing CD-R/RW discs, the performance rate may drop due to quality of the recorded data.

English

Français

29

<DRB1376> En