06Recording

1Press ‘G-Code’ to display the G-Code program screen.

You can also access this screen from the Home Menu (press HOME MENU, select Timer Recording, then G- Code).

G-Code

 

 

 

 

G-Code#

 

3 9 9 2 4

0

9 to input

Rec Mode

MN21

 

REC MODE to change

 

 

to change level

 

 

 

 

Rec Times

Once

Daily Weekly

 

to change

 

 

 

Use the

number buttons to enter the G-Code programming number. (To clear the last digit entered, press CLEAR.)

Press REC MODE to select FINE, SP, LP, EP or AUTO (See Recording time and picture quality on page 42). If Manual Recording is on, then you can also select the MN setting.

• Use the (cursor left/right) buttons to select the Once, Daily or Weekly recording option.

2After making the settings, press ENTER. The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited.

If you haven’t set up the guide channels (or at least the guide channel for the number that you entered), the recorder will prompt you to enter the channel number that the TV program is showing on.

Tip

You can check the timer program settings by pressing TIMER REC to display the timer recording screen.

G-Code programming with the power off

You can enter a G-Code programming number when the recorder is in standby.

G-CODE

CLEAR

ENTER

Important

You can’t use this feature until you have set up the guide channels. See G-Code CH Setting on page 77.

You can’t change the recording mode.

You can’t program daily or weekly timer recordings.

1 Press ’G-Code’.

The front panel display shows the current recording mode and prompts you to enter the G-Code programming number.

G - COD E

2 Use the number buttons to enter the number.

2 9 32 4

• To clear the last digit entered, press CLEAR.

3 Press ENTER.

The display shows the timer settings:

Date

Start time

End time

Recording channel.

If CODE ERROR appears in the display, check that the number is correct and that the guide channel is set (see G-Code CH Setting on page 77), then set the timer recording again.

If CAN’T SET appears in the display, it means that although you entered a valid number, the program has already finished.

Extending a timer recording in progress

You can extend a timer recording beyond the programmed end time in two different ways. This can be useful if a broadcast program overruns, for example.

CLEAR

ENTER

HOME

MENU

PREV NEXT

REC

STOPREC

TIMER REC

48

En

Page 48
Image 48
Pioneer DVR-320-S Code programming with the power off, Cod E, Extending a timer recording in progress