Printer Menus
Using the Service Menu (continued)
1. Adjust Print (continued)
I. Bank A to Sensor/Bank B to Sensor
•Bank A to Sensor - Use this option to set the distance between the sensor and the first head in Bank A.
•Bank B to Sensor
Set the Test Pattern printed by the bank of Print Heads to locate the vertical bar 1/2 inch from the edge of the media.
Example: Print out an adjust print Test Pattern by pressing the Test button while in the Adjust Print menu. The printer will print a Test Pattern like the example below.
Edge of media
Measure this distance
The distance from the leading edge of the media to the leading edge of the heavy bar on the Test Pattern should be 1/2 inch.
If the measurement is incorrect, change the ‘offset’ set- ting using the + or – buttons, then press the Enter button to select the desired value. An Asterisk (*) will appear in front of the new selection.
Take another test print and measure again. If necessary, repeat the process until you obtain the leading edge margin of 1/2 inch.
