4 | 4. There are two spoke magnet options. | |
| ||
| You only need to install one of them. | |
| Check which of the magnets fits the spoke | |
| of your bike best. One (A) is installed by | |
| rotating it around the spoke before putting | |
| the metal cover on, another (B) by | |
| tightening the screw. The magnet must be | |
| facing the speed sensor. | |
| 5. | |
A or B | magnet and the sensor so that the magnet | |
| passes the sensor closely but does not | |
| touch it. The maximum distance between | |
| the speed sensor and the spoke magnet | |
5 | should be 5 mm/ 0.2". Once positioned | |
correctly, tighten the cable ties securely | ||
| ||
| and cut off any excess cable tie ends. | |
| Your safety is important to us. While riding | |
| your bike, please keep your eyes on the | |
| road to prevent possible accidents and | |
| injury. Check that you can turn the handle | |
| bar normally and cable wires for brakes or | |
| gearing do not catch on the sensor. Check | |
| also that the sensor does not disturb | |
| pedalling or the use of brakes or gearing. |
How to put the transmitter on
1.Attach the transmitter to the elastic strap.
2.Adjust the strap length to fit snugly and comfortably. Secure the strap around your chest, just below the chest muscles, and buckle it.
3.Lift the transmitter off your chest and moisten the grooved electrode areas on the back.
4.Check that the wet electrode areas are firmly against your skin and the Polar logo is in a central, upright position.
How to start measuring your heart rate
1.Begin with the display that shows the time of day.
2.Keep the wrist receiver within
1 metre/ 3 feet of your transmitter.
3.Check that you are not near other people that have heart rate monitors, high voltage power lines, televisions, mobile phones or other sources of electromagnetic disturbance.
A 10 | A 11 |