|
| Chapter 3 - Initial System Configuration |
|
|
|
Table | ||
|
|
|
| Field | Description |
|
|
|
| Prefix (cont.) | You can define several Network Services on the |
|
| MCU with each one of them containing one or |
|
| several IP cards. When a firewall is used, two IP |
|
| Network Services are usually defined; one for the |
|
| card that is connected to the external network and |
|
| the other one that includes all the remaining cards |
|
| (those connected to the internal network). |
|
|
|
| Refresh H.323 | Enter the frequency in which the system informs the |
| Registration Every | gatekeeper that it is active by |
| n Seconds | address and aliases of the IP cards to the |
|
| gatekeeper. If the IP card does not register within the |
|
| defined time interval, the gatekeeper will not refer |
|
| calls to this IP card until it |
|
| set to 0, |
|
| Note: It is recommended to use default settings. |
|
|
|
The following table describes the gatekeeper modes that can be configured with each of the listed gatekeepers.
Table
Gatekeeper Modes/ | Basic | Board | Pseudo | Register as | ||
Types | Hunting | Gatekeeper | Gateway | |||
| ||||||
|
|
|
|
|
| |
Radvision | + | + | + | + | ||
Radvision ECS | + | + | + | + | ||
VCON MXM | + | + | + | + | ||
Cisco MCM | - | - | - | + | ||
PathNavigator | + | + | + | + | ||
| Shading indicates the preferred configuration mode |
| ||||
|
|
|
|
|
|
12. Click Next.