Hardware Requirements

The following hardware components are required to connect the Remote Notification function.

·Modem: Basic external PC modem supporting the following AT commands.

E0 --- Do not echo characters in command state.

M0 --- Turn speaker off.

N0 --- Handshake only at speed specified by S37.

Q0 --- Return result codes in both originate and answer mode.

V0 --- Display result codes as numbers.

X0 --- Provide basic result codes: CONNECT, NO CARRIER, and RING. &A0 --- Connect as answering modem when auto-answering.

&D0 --- Ignore status of DTR signal. &K0 --- Disable local flow control.

&Q5 --- Communicate in error control mode.

NOTE: Consult the modem manufacturer’s manual to confirm that the above commands are supported by your modem.

·Standard serial cable with a male DB25 connector on both ends.

·DB25 null modem adapter.

All the above items can be acquired at your local computer products supply store.

An alternative to purchasing a cable is to build your own serial cable using the following pin out description:

Powerware 9315 (200 kVA ---300 kVA) Operation	61
164201036 Rev. D 041500

Powerware 9315 operation manual Hardware Requirements