Manuals / Premio Computer / Kitchen Appliance / Kitchen Entertainment Center

Premio Computer Aries/Centella manual H/W Audio Optional, S/W Audio, Bios, Dimension, Mounting

Models: Aries/Centella

1 131

Download 131 pages 19.28 Kb

Page 32

Image 32

Introduction

-1 floppy port supports 1 FDD with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes.

-2 serial ports (COMA / COMB)

-1 parallel port supports SPP/EPP/ECP mode

-4 USB ports (Rear * 2 / Front * 2)

-PS/2 Keyboard/Mouse connector

-1 Line-In/Line-Out/Mic-In/Game port

H/W Audio (Optional)

zC-mediaCMI8738-6CH-LX

zSupports 6 channel Audio

zAC97 2.1 compliant

S/W Audio

z2-channel Audio Codec

z4-channel Audio Codec (Optional)

zAC97 2.1 compliant

BIOS

zThe mainboard BIOS provides “Plug & Play” BIOS which detects the peripheral devices and expansion cards of the board automatically.

zThe mainboard provides a Desktop Management Interface (DMI) func- tion which records your mainboard specifications.

Dimension

zMicro ATX Form Factor (24.4cm x 22.4cm)

Mounting

z6 mounting holes

1-3

Page 32

Image 32

Premio Computer Aries/Centella manual H/W Audio Optional, S/W Audio, Bios, Dimension, Mounting

Contents

Aries/Centella u s e r m a n u a lSystem Manual ii Premio System Manual CopyrightDisclaimers Contents GETTING STARTEDUPGRADING GETTING HELPAPPENDIX iv Premio System ManualWarranty Policy Service Under WarrantyGetting Started System UnitKeyboard Mouse System UnitSetting Up 2 Premio System ManualSwitches and Indicators The hard drive indicator lights when the hard drive is in useThe power indicator lights when the system is on The CD-ROM drive reads information on CDs4 Premio System Manual Reset ButtonCD ROM Drive Floppy DriveUpgrading Opening the System Unit 6 Premio System ManualInstalling an Expansion Card Installing a Hard Drive 8 Premio System ManualMonitor Does Not Work TroubleshootingGetting Help 10 Premio System Manual Keyboard Does Not WorkMouse Does Not Work System Unit Problems Hard Drive Problems12 Premio System Manual Technical SupportPremio on the Internet Warranty Policy AppendixWarranty Premio Product14 Premio System Manual Service Under WarrantyExclusions from Limited Warranty Programs FCC Standards Important Safety Instructions 16 Premio System ManualA. When the power cord or plug is damaged or frayed MS-6534 Micro ATX Mainboard Version G52-MA00417 MICRO-STAR INTERNATIONALVOIR LA NOTICE DINSTALLATION AVANT DE RACCORDER AU RESEAU FCC-B Radio Frequency Interference StatementMicro-Star International MS-6534 Tested to comply with FCC Standard For Home or Office UseEdition Copyright NoticeTrademarks Revision HistorySafety Instructions Chapter 1. Introduction ContentsChapter 2. Hardware Setup Chapter 3. AWARD BIOS Setup Entering SetupJumpers SlotsGlossary Chapter 4. AMI BIOS SetupAppendix A. Using 4-/6-channel Audio Function Introduction1 Mainboard Specification ChipsetMain Memory SlotsBIOS DimensionH/W Audio Optional S/W AudioMainboard Layout MS-6534 Micro-ATX MainboardChapter IntelQuick Components Guide IntroductionComponent FunctionKey Features Hardware Setup Overheating will seriously damage the CPU Installing the CPUCentral Processing Unit CPU Installing the CPU Fan LeversCPU Core Speed Derivation Procedure thenOverclocking This motherboard is designed to support overclockingMemory Introduction to SDRAMYou can install memory modules in any combination as follows Installing DIMM ModulesDIMM Modules Combination Power Supply ATX 20-Pin Power ConnectorJPW1 ATX 12V Power Connector JPW1Chapter Hardware Setup Mouse ConnectorBack Panel 6-pin Female Keyboard ConnectorUSB Connectors Pin Definition Parallel Port ConnectorHardware Setup Serial Port Connectors COM A & COM B Joystick/Midi ConnectorAudio Port Connectors FunctionConnectors Floppy Disk Drive Connector FDD1jumper setting instructions Hard Disk Connectors IDE1 & IDE2Primary IDE Connector 2-15 Case Connectors FP1 & FP2Hardware Setup Power Switch Reset SwitchPower LED FP1 2-pin/3-pin dual color power LED 2-pin LED is connected to pinPower LED FP2 LEDStatusDescription LEDStatusKeylock FP1 only HDD LEDSpeaker FP1 only Power Saving Switch Connector JGS1 Wake On LAN Connector JWOL1JGS1 JWOL1Chapter Wake On Ring Connector JMDM1 OptionalNote Modem wake-up signal is active “low” Connectivity Design Guide IrDA Infrared Module Connectors IR1 & IR2Hardware Setup Fan Power Connectors CFAN1/SFAN1 1. Always consult the vendor for proper CPU cooling fanHardware Setup CD-In/Aux Line-In/Modem-In Connector CDIN1/AUXIN1/ MDMIN1CDIN1 connector is for CD-ROM audio connector USB Front Panel Connectors USB1 & USB2 ChapterPanel I/O Connectivity Design Guide Front Panel Audio Connector JAUDIO1Hardware Setup Jumpers Clear CMOS Jumper JBAT1Slots AGP Accelerated Graphics Port SlotPCI Slots CNR Communication Network Riser Slot2-28 PCI Interrupt Request RoutingAGP & PCI Slot 1 shared PCI Slot 2 & AC97 shared AWARD BIOS Setup AWARD BIOS SetupHit DEL if you want to run SETUP Entering SetupControl Keys Getting Help MainMenuSub-Menu General Help F1The Main Menu Standard CMOS FeaturesAdvanced BIOS Features Advanced Chipset FeaturesPnP/PCI Configurations Load Fail-Safe DefaultsLoad Optimized Defaults Set Supervisor PasswordStandard CMOS Features Datemonth dateDrive A/B VideoAll Errors The system stops when any error is detectedNo Errors The system doesn’t stop for any detected errorCPU L1 & L2 Cache Advanced BIOS FeaturesAnti-Virus Protection Quick Boot 1st/2nd/3rd Boot DeviceThe system will boot from floppy drive The system will boot from LS-120 driveTypematic Rate Setting SetupThe password prompt appears only when end users try to run SetupPage Advanced Chipset Features Note Change these settings only if you are familiar with the chipsetConfigure SDRAM Timing CAS# LatencyEnabled and Disabled RAS# to CAS# DelayRAS# Precharge DRAMDataIntegrityMode↑↓→← Integrated PeripheralsAWARD BIOS Setup On-ChipPrimary/SecondaryPCIIDE IDE Primary/Secondary Master/Slave PIOIDEPrimary/SecondaryMaster/SlaveUDMA USB ControllerOnboard/CNR LAN selection IDEHDDBlockModeFloppyController Serial Port A/Babled and Disabled IRDuplexModeIR Pin Select Parallel PortACPIStandbyState Power Management SetupIPCAFunction PowerManagement/APM Power Button FunctionPower Off The power button functions as a normal power-onResume By RTC Alarm DateofMonthAlarmTimehhmmssAlarm POWERONFunctionSleep State LED Hot Key Power ONPower Again PnP/PCI Configurations PNP OS InstalledReset Configuration Data Resources Controlled ByIRQ Resources PCI/VGA Palette SnoopPC Health Status CPU Critical TemperatureFrequency/Voltage Control CPU Ratio SelectionAuto Detect PCI Clock SpreadSpectrumAWARD BIOS Setup Load Fail-Safe/Optimized Defaults When you select Load Optimized Defaults, a message as below appears AWARD BIOS SetupLoad Optimized Defaults ↑ ↓ → ←Set Supervisor/User Password 3-30About Supervisor Password & User Password Save & Exit Setup Exit Without Saving AMI BIOS Setup AMI BIOS SetupSelecting the First Boot Device Entering SetupDELSetup F11Boot MenuAMI BIOS Setup Control KeysDefault Settings Getting HelpMainMenu General Help F1Standard CMOS Setup BIOS Features SetupChipset Features Setup Power Management SetupPNP/PCI Configuration Hardware Monitor SetupLoad Optimal Defaults Load Fail Safe DefaultsStandard CMOS Setup Datemonth dateFloppyDriveA/B Boot Sector Virus ProtectionPri Master/Pri Slave/Sec Master/Sec Slave BIOS Features Setup Quick Boot1st/2nd/3rd Boot Device The system will boot from the first HDDThe system will boot from the CD-ROM The system will boot from the SCSIThe system will boot from the Network drive The system will boot from the first BBS BIOS BootPassword Check Boot OS/2 for DRAM 64MBSystem BIOS Cacheable SwapFloppyChipset Features Setup Note Change these settings only if you are familiar with the chipsetConfigure DRAM Timing by CAS# LatencyRAS# to CAS# Delay Precharge DelayDRAMIntegrityMode AGP Aperture SizeACPIStandbyState Power Management SetupIPCAFunction PowerManagement/APM USB Wakeup From S3Mouse Wakeup From S3 Keyboard Wakeup From S3Power Button Function Resume By RTC AlarmRTCAlarm Date/Hour/Minute/Second Monitor and IgnoreNote If you change these settings, you must reboot the system until it enters the operating system and then power off the system. By doing so, the changed settings will come into effect next time you power on the system Power AgainPCI VGA Palette Snoop PNP/PCI ConfigurationClear ESCD DMA Channel 0/1/3/5/6/7 IRQ 3/4/5/7/9/10/11Integrated Peripherals USB ControllerUSB Legacy Support On-ChipIDEAC’97 Audio AC’97ModemFloppyController OptionIR Pin Select Parallel PortParallel Port Mode EPP VersionOnBoardGamePort AMI BIOS Setup9, 10 and Hardware Monitor Setup CPU Ratio SelectionCPU FSB Clock Mhz SpreadSpectrumChassis Intrusion Optional Load Optimal Load Optimal/Fail Safe DefaultsDefaultsY/N? N LOAD FAIL SAFE DEFAULTS AMI BIOS SetupLoad Fail Safe DefaultsY/N? N Enter new Supervisor/User Passwordsupervisor password Additionally, when a password is enabled, you can also have AMIBIOS to request a password each time the system is booted. This would prevent unauthorized use of your computer. The setting to determine when the pass- word prompt is required is the PASSWORD CHECK option of the BIOS FEA- TURES SETUP menu. If the PASSWORD CHECK option is set to Always, the password is required both at boot and at entry to Setup. If set to Setup, password prompt only occurs when you try to enter Setup About Supervisor Password & User PasswordIDE HDD AUTO Detection ChapterSAVE to CMOS and EXITY/N? Y Save & Exit SetupSAVE & EXIT SETUP Exit Without Saving Quit withoutsavingY/N? N EXIT WITHOUT SAVINGUsing 4-/6-channel Audio Function A Using 4-/6-channel Audio FunctionInstalling C-Media Drivers Hardware ConfigurationTo install C-Media drivers 2. Click on C-Media Sound DriversClick here Software ConfigurationTo set the multi-channel configuration