Manuals / Premio Computer / Kitchen Appliance / Kitchen Entertainment Center

Premio Computer Aries/Centella Premio System Manual, Reset Button, CD ROM Drive, Floppy Drive

Models: Aries/Centella

1 131

Download 131 pages 19.28 Kb

Page 9

Image 9

4 Premio System Manual

Desktop system

Reset Button		CD ROM Drive

	Hard Drive Indicator	Floppy Drive
	Power Indicator	Power Switch

The reset button restarts the system.

The hard drive indicator lights when the hard drive is in use.

The power indicator lights when the system is on.

The power switch turns the system on and off.

The CD-ROM drive reads information on CDs.

The floppy drive reads and writes information on diskettes.

Page 9

Image 9

Premio Computer Aries/Centella manual Premio System Manual, Reset Button, CD ROM Drive, Floppy Drive

Contents

u s e r m a n u a l Aries/CentellaSystem Manual Copyright Disclaimersii Premio System Manual GETTING STARTED ContentsUPGRADING GETTING HELPiv Premio System Manual APPENDIXWarranty Policy Service Under WarrantySystem Unit Getting StartedKeyboard Mouse System Unit2 Premio System Manual Setting UpThe hard drive indicator lights when the hard drive is in use Switches and IndicatorsThe power indicator lights when the system is on The CD-ROM drive reads information on CDsReset Button 4 Premio System ManualCD ROM Drive Floppy DriveUpgrading 6 Premio System Manual Opening the System UnitInstalling an Expansion Card 8 Premio System Manual Installing a Hard DriveTroubleshooting Getting HelpMonitor Does Not Work Keyboard Does Not Work Mouse Does Not Work10 Premio System Manual Hard Drive Problems System Unit ProblemsTechnical Support Premio on the Internet12 Premio System Manual Appendix Warranty PolicyWarranty Premio ProductService Under Warranty Exclusions from Limited Warranty Programs14 Premio System Manual FCC Standards 16 Premio System Manual Important Safety InstructionsA. When the power cord or plug is damaged or frayed MICRO-STAR INTERNATIONAL MS-6534 Micro ATX Mainboard Version G52-MA00417FCC-B Radio Frequency Interference Statement VOIR LA NOTICE DINSTALLATION AVANT DE RACCORDER AU RESEAUMicro-Star International MS-6534 Tested to comply with FCC Standard For Home or Office UseCopyright Notice EditionTrademarks Revision HistorySafety Instructions Contents Chapter 2. Hardware SetupChapter 1. Introduction Entering Setup Chapter 3. AWARD BIOS SetupJumpers SlotsChapter 4. AMI BIOS Setup Appendix A. Using 4-/6-channel Audio FunctionGlossary Introduction1 Chipset Mainboard SpecificationMain Memory SlotsDimension BIOSH/W Audio Optional S/W AudioMS-6534 Micro-ATX Mainboard Mainboard LayoutChapter IntelIntroduction Quick Components GuideComponent FunctionKey Features Hardware Setup Installing the CPU Central Processing Unit CPUOverheating will seriously damage the CPU Levers Installing the CPU Fanthen CPU Core Speed Derivation ProcedureOverclocking This motherboard is designed to support overclockingIntroduction to SDRAM MemoryInstalling DIMM Modules DIMM Modules CombinationYou can install memory modules in any combination as follows ATX 20-Pin Power Connector Power SupplyATX 12V Power Connector JPW1 ChapterJPW1 Mouse Connector Back PanelHardware Setup Keyboard Connector USB Connectors6-pin Female Parallel Port Connector Hardware SetupPin Definition Joystick/Midi Connector Serial Port Connectors COM A & COM BAudio Port Connectors FunctionFloppy Disk Drive Connector FDD1 ConnectorsHard Disk Connectors IDE1 & IDE2 Primary IDE Connectorjumper setting instructions Case Connectors FP1 & FP2 Hardware Setup2-15 Reset Switch Power SwitchPower LED FP1 2-pin/3-pin dual color power LED 2-pin LED is connected to pinLEDStatus Power LED FP2Description LEDStatusHDD LED Speaker FP1 onlyKeylock FP1 only Wake On LAN Connector JWOL1 Power Saving Switch Connector JGS1JGS1 JWOL1Wake On Ring Connector JMDM1 Optional Note Modem wake-up signal is active “low”Chapter IrDA Infrared Module Connectors IR1 & IR2 Hardware SetupConnectivity Design Guide 1. Always consult the vendor for proper CPU cooling fan Fan Power Connectors CFAN1/SFAN1CD-In/Aux Line-In/Modem-In Connector CDIN1/AUXIN1/ MDMIN1 CDIN1 connector is for CD-ROM audio connectorHardware Setup Chapter USB Front Panel Connectors USB1 & USB2Front Panel Audio Connector JAUDIO1 Hardware SetupPanel I/O Connectivity Design Guide Clear CMOS Jumper JBAT1 JumpersAGP Accelerated Graphics Port Slot SlotsPCI Slots CNR Communication Network Riser SlotPCI Interrupt Request Routing AGP & PCI Slot 1 shared PCI Slot 2 & AC97 shared2-28 AWARD BIOS Setup AWARD BIOS SetupEntering Setup Control KeysHit DEL if you want to run SETUP MainMenu Getting HelpSub-Menu General Help F1Standard CMOS Features The Main MenuAdvanced BIOS Features Advanced Chipset FeaturesLoad Fail-Safe Defaults PnP/PCI ConfigurationsLoad Optimized Defaults Set Supervisor PasswordDate Standard CMOS Featuresmonth dateVideo Drive A/BThe system stops when any error is detected All ErrorsNo Errors The system doesn’t stop for any detected errorAdvanced BIOS Features Anti-Virus ProtectionCPU L1 & L2 Cache 1st/2nd/3rd Boot Device Quick BootThe system will boot from floppy drive The system will boot from LS-120 driveSetup Typematic Rate SettingThe password prompt appears only when end users try to run SetupPage Note Change these settings only if you are familiar with the chipset Advanced Chipset FeaturesConfigure SDRAM Timing CAS# LatencyRAS# to CAS# Delay Enabled and DisabledRAS# Precharge DRAMDataIntegrityModeIntegrated Peripherals AWARD BIOS Setup↑↓→← IDE Primary/Secondary Master/Slave PIO On-ChipPrimary/SecondaryPCIIDEIDEPrimary/SecondaryMaster/SlaveUDMA USB ControllerIDEHDDBlockMode Onboard/CNR LAN selectionFloppyController Serial Port A/BIRDuplexMode abled and DisabledIR Pin Select Parallel PortPower Management Setup IPCAFunctionACPIStandbyState Power Button Function PowerManagement/APMPower Off The power button functions as a normal power-onDateofMonthAlarm Resume By RTC AlarmTimehhmmssAlarm POWERONFunctionHot Key Power ON Power AgainSleep State LED PNP OS Installed PnP/PCI ConfigurationsReset Configuration Data Resources Controlled ByPCI/VGA Palette Snoop IRQ ResourcesCPU Critical Temperature PC Health StatusCPU Ratio Selection Frequency/Voltage ControlAuto Detect PCI Clock SpreadSpectrumAWARD BIOS Setup Load Fail-Safe/Optimized Defaults AWARD BIOS Setup When you select Load Optimized Defaults, a message as below appearsLoad Optimized Defaults ↑ ↓ → ←3-30 Set Supervisor/User PasswordAbout Supervisor Password & User Password Save & Exit Setup Exit Without Saving AMI BIOS Setup AMI BIOS SetupEntering Setup Selecting the First Boot DeviceDELSetup F11Boot MenuControl Keys AMI BIOS SetupGetting Help Default SettingsMainMenu General Help F1BIOS Features Setup Standard CMOS SetupChipset Features Setup Power Management SetupHardware Monitor Setup PNP/PCI ConfigurationLoad Optimal Defaults Load Fail Safe DefaultsDate Standard CMOS Setupmonth dateBoot Sector Virus Protection Pri Master/Pri Slave/Sec Master/Sec SlaveFloppyDriveA/B Quick Boot BIOS Features Setup1st/2nd/3rd Boot Device The system will boot from the first HDDThe system will boot from the SCSI The system will boot from the CD-ROMThe system will boot from the Network drive The system will boot from the first BBS BIOS BootBoot OS/2 for DRAM 64MB Password CheckSystem BIOS Cacheable SwapFloppyNote Change these settings only if you are familiar with the chipset Chipset Features SetupConfigure DRAM Timing by CAS# LatencyPrecharge Delay RAS# to CAS# DelayDRAMIntegrityMode AGP Aperture SizePower Management Setup IPCAFunctionACPIStandbyState USB Wakeup From S3 PowerManagement/APMMouse Wakeup From S3 Keyboard Wakeup From S3Resume By RTC Alarm Power Button FunctionRTCAlarm Date/Hour/Minute/Second Monitor and IgnorePower Again Note If you change these settings, you must reboot the system until it enters the operating system and then power off the system. By doing so, the changed settings will come into effect next time you power on the systemPNP/PCI Configuration Clear ESCDPCI VGA Palette Snoop IRQ 3/4/5/7/9/10/11 DMA Channel 0/1/3/5/6/7USB Controller Integrated PeripheralsUSB Legacy Support On-ChipIDEAC’97Modem AC’97 AudioFloppyController OptionParallel Port IR Pin SelectParallel Port Mode EPP VersionAMI BIOS Setup 9, 10 andOnBoardGamePort CPU Ratio Selection Hardware Monitor SetupCPU FSB Clock Mhz SpreadSpectrumChassis Intrusion Optional Load Optimal/Fail Safe Defaults DefaultsY/N? NLoad Optimal AMI BIOS Setup Load Fail Safe DefaultsY/N? NLOAD FAIL SAFE DEFAULTS Supervisor/User Password supervisor passwordEnter new About Supervisor Password & User Password Additionally, when a password is enabled, you can also have AMIBIOS to request a password each time the system is booted. This would prevent unauthorized use of your computer. The setting to determine when the pass- word prompt is required is the PASSWORD CHECK option of the BIOS FEA- TURES SETUP menu. If the PASSWORD CHECK option is set to Always, the password is required both at boot and at entry to Setup. If set to Setup, password prompt only occurs when you try to enter SetupChapter IDE HDD AUTO DetectionSave & Exit Setup SAVE & EXIT SETUPSAVE to CMOS and EXITY/N? Y Quit without Exit Without SavingsavingY/N? N EXIT WITHOUT SAVINGUsing 4-/6-channel Audio Function Using 4-/6-channel Audio Function AHardware Configuration Installing C-Media DriversTo install C-Media drivers 2. Click on C-Media Sound DriversSoftware Configuration To set the multi-channel configurationClick here