AWARD® BIOS Setup
not, it is disabled. Disable the controller if you want to use other controller cards to connect to a modem. Settings: Auto and Disabled.
Onboard/CNR LAN selection
Use the item to enable or disable the onboard or external CNR LAN device. Settings:Auto, Onboard and Ext. CNR.
IDEHDDBlockMode
This allows your hard disk controller to use the fast block mode to transfer data to and from the hard disk drive. Block mode is also called block transfer, multiple commands or multiple sector read/write. Enabled enables IDE controller to use block mode; Disabled allows the controller to use standard mode.
FloppyController
The item is used to enable or disable the onboard Floppy controller. Select Enabled when you have installed a floppy disk drive and want to use it.
Serial Port A/B
The items specify the base I/O port address and IRQ for the onboard Serial Port A (COM A)/Serial Port B (COM B). Selecting Auto allows BIOS to automati- cally determine the correct base I/O port address. Settings: Disabled, 3F8/ IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 and Auto.
Serial Port B Mode
The field allows you to specify the operation mode for serial port “COM B”. Settings are:
IrDA : | |
ASKIR : | Amplitude Shift Keyed Infrared Port |
Normal: |
RxD,TxDActive
The item determines the active of RxD, TxD. Settings are “Hi, Hi”, “Hi, Lo”, “Lo, Hi” and “Lo, Lo”.
IR Transmission Delay
The field enables or disables IR transmission delay function. Settings: En-