Printronix P3000 Series Line Spacing 1/8 Inch 8 lpi, Display when the 6/8 LPI switch is pressed

Line Spacing 1/8 Inch (8 lpi)

	ASCII	Hex	Decimal
P–Series	SFCC LPI;n
	SFCC 0	SFCC 30	SFCC 48
Serial	ESC 0	1B 30	27 48
Purpose	Specifies continuous line spacing at 1/8–inch increments (8 lpi).
Comment	When the 1/8–inch line spacing control code is received, all lines are printed at 8 lpi
	until a new line spacing is selected or the power is reset. The control code line spac-
	ing selection overrides the control panel line spacing setting and 8 lpi is reflected on
	the display when the 6/8 LPI switch is pressed.
	The value of n can only be 6 or 8. When using SFCC LPI;n in the P–Series mode and
	n = 8, this command sets line spacing to 1/8 inch. Values of n other than 6 or 8 cause
	an error message (Command Line Error Messages are listed on page 6–3).
Example	The following example illustrates 1/8–inch line spacing.

6–48 Programming