Printronix P3000 Series manual Line Spacing 8 or 10.3 lpi One Line Only, Bility

Line Spacing 8 or 10.3 lpi (One Line Only)

	ASCII	Hex	Decimal
P–Series	ACK	06	06
	SFCC f	SFCC 66	SFCC 102
Serial	N/A	N/A	N/A
Purpose	Selects line spacing of 1/8 or 7/72 inch for the current line only.
Comment	The default line spacing is reselected automatically after one line. Select line spac-
	ing either by the control panel 6/8 LPI switch or by line spacing control codes. The
	control code setting overrides the setting on the display.
	8 and 10.3 lpi spacing for one line applies only to P–Series programming compati-
	bility.
	If the alternate line spacing selected from the control panel is 8 lpi, the ACK control
	code will set the line spacing to 8 lpi. If 10.3 lpi was selected from the control panel,
	the ACK control code will set line spacing to 10.3 lpi (7/72 inch).
	In Serial Matrix printer protocol, you can use this line spacing command for a single
	line with ESC J (Line Feed n/216–Inch), where n=27 for 8 lpi, or n= 21 for 10.3 lpi,
	and Line Feed = Newline.
	In Serial Matrix compatible control code ESC 0 and P–Series SFCC 0 can be used
	for continuous 1/8–inch line spacing.
Example	The following example illustrates printing a single line of text at 8 lpi.

Programming 6–49