Printronix P3000 Series manual Skip-Over Perforation

Skip–Over Perforation

	ASCII	Hex	Decimal
P–Series	N/A	N/A	N/A
Serial	ESC N n	1B 4E n	27 78 n

Purpose	Selects the number of lines (at the current line spacing) for the paper “skip” at the
	bottom of the perforated page.
where	n = 1 to 127 to select the number of lines to skip. If the value of n exceeds the
	current forms length, it is ignored.
Comment	The actual distance set is the product of n and the current line spacing. The factory
	default value is to disable skip–over perforation. You can specify the default value.
	Setting a new forms length (ESC C) resets skip–over perforation to zero.
	This feature is disabled whenever vertical tabs are set.
	You can also select skip–over perforation from the control panel; however, vertical
	tabs within the skip–over perforation zone, as set by the control panel, are ignored.
	The control code skip–over perforation setting from the host computer overrides the
	control panel setting.

6–62 Programming