Printronix P3000 Series manual Factory Default Configuration Values

Factory Default Configuration Values

The printer comes with a set of Printronix factory configuration values, shown in Table 3–1. These values are set at the factory, and are operational when the printer is received. New values can be saved and applied as necessary for each application, but factory default values remain accessible using the LOAD PARAMETERS configuration. On the Control Panel Configuration Diagram, factory configu- ration values are indicated by a asterisk (*). (The asterisk is not shown on the printer display.) Refer to the Configuration Procedure on page 3–5 to change values of the configuration parameters for your application.

Table 3–1. Printronix Factory Default Configuration Values

Configuration	Factory Default	Configuration	Factory Default
Parameter	Value	Parameter	Value
Forms Length	11.0 Inches	Parallel Interfaces:
Line Spacing	6 lpi	Data Bit 8	Enable
Print Mode	DP 10 cpi
		Data Polarity	Standard
Select Set	IBM PC	Resp. Polarity	Standard
Select Language	ASCII	PI Line	Disable
Select Subset	IBM PC Graphics	Strobe Polarity	Standard
		Latch Data On	Leading Edge
Printer Protocol	P–Series	Serial RS–232 Interface:
Printer Select	Disable	Data Protocol	X–On / X–Off
Paper Advance Switch	PRINT + PAP ADV	Data Rate	9600 Baud
Power On State	Online	Word Length	8 Bits
		Stop Bit	One
Alarm On Fault	Enable
		Parity	None
Unidirectional	Disable
		Bit 8 Function	Font Select
Select SFCC	01 SOH	CD AND CTS	Disable
80–9F Hex	Control Codes	DSR	Disable
Control Code 08	Double High	Data Term Ready	Online and BNF
Control Code 06	8 lpi	Request to Send	Online and BNF
Overstrike	Enable	Reverse Channel	Online and BNF
Auto Line Feed	After Full Line
Define CR Code	CR = CR
Define LF Code	LF = CR + LF
VFU Select	EVFU
Perforation Skip	00.0 Inch
Paper Empty	End of Paper
PMD Fault	Enable
Print Width	13.2 Inches
Host Interface	Centronics

3–4 Configuration