Quatech DP500, IN5000, HD500 user manual Cable Replacement Master Configuration

AirborneDirect™ Users Guide			Quatech, Inc.
	Step	Description
	Press Reload [Button]	Reloads the WLAN Settings page.
	Optional	Reloads the Serial Port Settings page. Select this is you have
	Press Reload [Button]	further configuration options to change.
	Optional	Restarts the device. After the device as rebooted it will create
	Press Restart [Button]	an AdHoc network with the name you gave the SSID. As long as
		the network is in range the wireless interface will connect.
	Table 44 - Cable Replacement - Master Configuration
	Step		Description
	Configure the device to use an AdHoc network		See section 17.2
			After the Commit at the end of the configuration
			press the Reload Button.
	Configure the device to use a static IP address on		See section 19.3
	the WLAN interface		After the Commit at the end of the configuration
			press the Reload Button.
	Configure the device to listen for a connection on		See section 20.2
	the tunnel port		After the Commit at the end of the configuration
			press the Reload Button.
	Navigation Bar		You will see a group of fields under the banner of
	Select Configuration		Interface and Network Parameters.
	Feature Link		The serial port must be configured to work with the
	Select Serial Port Settings		target device.
			This is a page showing the configuration options for
			the serial port.
	Select Serial Port Bit Rate		Select the appropriate bit rate to match the serial port
			the device will be connected to.
	Select Parity		Select the parity setting to match the serial port the
			device will be connected to, from the drop down list.
	Select Data Bits		Select the number of data bits to match the serial port
			the device will be connected to, from the drop down
			list.
	Select Stop Bits		Select the number of stop bits to match the serial port
			the device will be connected to, from the drop down
			list.
	Select Flow Control		Select the flow control option to match the serial port
			the device will be connected to, from the drop down
			list.
	Optional		Select the option to match the serial port the device
	Select Serial Assert		will be connected to, from the drop down list. This is
			only required if software flow control has been
			selected.
	Select Serial CLI Default Mode		Select Pass from the drop down menu.
	Press Commit [Button]		Saves changes to the device.
	Press Reload [Button]		Reloads the WLAN Settings page.

100-8510-110 2/21/2011 79