
Quatech, Inc. | AirborneDirect™ User Manual |
|
|
13.0 Configuring Device – Enterprise Serial (ABDG-SE-DP5XX)
The
13.1Connect a Host Computer
Connect the serial pigtail connector to the serial port on a host computer.
It may be necessary to use a gender changed that includes a Null Modem adapter.
13.2Interacting with the AirborneDirect™ device
On the Host computer, use a terminal emulation program to interact with the device issuing Quatech Command Line Interface (CLI) commands. CLI commands let you request status or change parameter settings. Press the Enter key (<CR>) after each command line you type. After the module starts, type the following CLI command to log in (you must log in before CLI commands can be recognized):
|
| Table 15 - UART Authentication | |||
|
|
|
|
|
|
| CLI Command |
|
| Description |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| Send Break Sequence |
|
| The serial port starts up in a listen mode waiting for a | |
|
|
|
| request for a data tunnel. To access the CLI mode in | |
|
|
|
| which | |
|
|
|
| sent. | |
|
|
|
| The default break sequence for the device is ÿ~ABD | |
|
|
|
| The sequence must be sent with no trailing characters. | |
|
|
|
| If received correctly the device will respond OK. | |
|
|
|
|
| |
| auth dpac dpac <CR> |
|
| The module responds with OK, indicating that it | |
|
|
|
| executed the command successfully. (If you did not | |
|
|
|
| receive OK, check the settings in your terminal emulation | |
|
|
|
| program). | |
|
|
|
|
|
|
You will have to break into CLI mode and log into the module after any reset or restart.
38 | 2/21/2011 |