1 - WARNINGS -
PAY ATTENTION TO THESE TERMS
DANGER:
Indicates the presence of immediate hazards which will cau- se severe personal injury, death or substantial property damage if ignored.
WARNING:
Indicates the presence of hazards or unsafe practices which could cause severe personal injury, death or substantial property damage if ignored.
CAUTION:
Indicates the presence of hazards or unsafe practices which could cause minor personal injury or product or property damage if ignored.
NOTICE:
Indicates special instructions on installation, operation, or maintenance which are important but not related to personal injury hazards.
DANGER: Make sure the gas on which the boiler will operate is the same type as that specified on the boiler rating plate and on the coloured sticker near the boiler gas connection.
WARNING: Should overheating occur or the gas supply valve fail to shut, do not turn off or disconnect the electrical supply to the boiler. Instead, shut off the gas supply at a location external to the boiler.
WARNING: Do not use this boiler if any part has been under water. Immediately call a qualified service technician to inspect the boiler and to replace any part of the control system and any gas control which has been under water.
AVERTISSEMENT: En cas de surchauffe ou de non fermeture de la vanne d’alimentation en gaz, n’éteignez ou ne débranchez pas l’alimentation électrique de la chaudière. Coupez plutôt l’alimentation en gaz à l’extérieur de la chaudière.
AVERTISSEMENT: N’utilisez pas cette chaudière si une partie de
WARNING: To minimize the possibility of improper operation, serious personal injury, fire, or damage to the boiler:
•Always keep the area around the boiler free of combustible materials, gasoline, and other flammable liquids and vapors.
•Boiler should never be covered or have any blockage to the flow of fresh air to the boiler.
WARNING: Risk of electrical shock. More than one disconnect switch may be required to
WARNING - CALIFORNIA PROPOSITION
65:This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
CAUTION: This boiler requires forced water circulation when the burner is operating. See minimum and maximum flow rates. Severe damage will occur if the boiler is operated without proper water flow circulation.
NOTE: Minimum 18 AWG, 105°C, stranded wire must be used for all low voltage (less than 30 volts) external connections to the unit. Solid conductors should not be used because they can cause excessive tension on contact points. Install conduit as appropriate. All high voltage wires must be the same size (105°C, stranded wire) as the ones on the unit or larger.
NOTE: When the boiler has been filled for the first time or the system has been drained and refilled, it will be necessary to release any air that may have become trapped within the appliance heat exchanger. Loosen the bleed screw until water is released and then close.
IMPORTANT, THERE ARE NO OTHER MANUAL AIR RELEASE VALVES LOCATED ON THE APPLIANCE.
The following instructions must be observed
–The boiler must only be used for its designated purpose, observing the Installation Instructions.
–Only use the boiler in the combinations and with the accessories and spares listed.
–Other combinations, accessories and consumables must only be used if they are specifically designed for the intended application and do not affect the system performance and the safety requirements.
–Maintenance and repairs must only be carried out by authorized professionals.
–You must report the installation of a condensing gas boiler to the relevant gas utility company and have it approved.
–You are only allowed to operate the condensing gas boiler with the combustion air/flue gas system that has been specifically designed and approved for this type of boiler.
–Please note that local permission for the flue system and the condensate water connection to the public sewer system may be required.
You must also observe:
–The local building regulations stipulating the installation rules.
–The local building regulations concerning the air intake and outlet systems and the chimney connection.
–The regulations for the power supply connection.
–The technical rules laid down by the gas utility company concerning the connection of the gas burner fitting to the local gas main.
–The instructions and standards concerning the safety equipment for the water/space heating system.
–The Installation Instructions for building heating systems.
–The boiler must be located in an area where leakage of the tank or connections will not result in damage to the area adjacent to the boiler or to lower floors of the structure. When such locations cannot be avoided, it is recommended that a suitable drain pan, adequately drained, be installed under the boiler. The pan must not restrict combustion air flow.
–The boiler must be installed such that the gas ignition system components are protected from water (dripping, spraying, rain etc.) during boiler operation and service.
–The boiler must not be installed on carpeting.
–The boiler must only be installed on a wall.
–Do not restrict or seal any air intake or outlet openings.
–If you find any defects, you must inform the owner of the system of the defect and the associated hazard in writing.
4
