Remote Maintenance by telnet

Remote Maintenance by telnet

Important

Remote Maintenance should be password-protected so that access is allowed to administrators only.

The password is the same as the one of Web Image Monitor administrator. When the password is changed using “mshell”, other passwords change also.

Some commands cannot be used depending on your printer.

Using telnet

Follow the procedure below to use telnet.

Important

Only one user at a time can log on to perform remote maintenance.

A

Use the IP address or the host name of the printer to start telnet.

B

% telnet “IP_address”Enter your user name and password.

6

Contact your network administrator for information about the settings.

C D

Enter a command.Quit telnet.msh> logout

The configuration message about saving the changes appears.

E Enter “yes” to save the changes, and then press the {OK} key.

If you do not want to save the changes, enter “no”, and then press the {OK} key. To make further changes, enter “return” at the command line, and then press the {OK} key.

Note

If the message “Can not write NVRAM information” appears, the changes are not saved. Repeat the procedure above.

When the changes are saved, the network interface board is reset automat- ically with that changes.

When the network interface board resets, the print job in print process will be printed. However, print jobs in queue will be canceled.

221