
Paper and Other Media
|
| Loading Envelopes |
|
| As there are many kinds of envelopes, |
|
| be sure to check if those to be used are |
1 |
| |
| supported by this printer. |
Reference
For more information about enve- lopes, see p.10 “Envelopes”.
Important
❒Even if the optional envelope feed- er is not installed, you can select envelope sizes for Tray 2 and Tray 3 using the control panel. Howev- er, you cannot load envelopes until the optional envelop feeder unit is installed.
❒To install the envelope feeder unit, the optional paper feed unit must be installed. See “Attaching Enve- lope Feeder Unit Type 610”, Setup Guide.
Loading envelopes onto the Bypass Tray Reference
With the bypass tray, you can load up to 10 envelopes at the same time. For more information about envelopes, see p.10 “Envelopes”.
To open and close the bypass tray, see p.19 “Opening and Closing the Bypass Tray”
A Load envelopes until they stop, with the print side up and the sides of the flaps on the left as shown below.
ZKGY411E
Important
❒Confirm that the envelope flaps are securely folded down, and that there is no air inside the en- velopes.
Note
❒Confirm that the top of the stack is not higher than the limit mark on the side guides.
❒Do not push the stack of enve- lopes with too much force.
B Slide the side guides against the edge of the envelope stack. Note
❒Confirm that the edges of enve- lopes fit under the side guides.
24