Ricoh AP610N OHP transparencies, Envelopes

Paper and Other Media

OHP transparencies

	Printer setup	Press [Paper Input] menu, [Paper Type], and then [Transparency] on
		the control panel.
1		Note

❒The paper type selected using the printer driver overrides that selected using the control panel.

Printer driver setup	Click [Transparency] in the [Type:] list.
Enabled paper feeding tray	Bypass tray
Number of sheets that can	Load only one OHP transparency at the same time onto the bypass
be set	tray.
Both-sided printing	Not possible
Additional cautions	• Print speed for OHP transparencies is slower than for plain pa-
	per.
	• Due to switching modes, the machine will be on standby for
	thirty or forty seconds after the job was received.

Envelopes

Printer setup	Press [Paper Input] menu, [Paper Type], and then press [Thick Paper]
	on the control panel.

	Note
	❒ The paper type selected using the printer driver overrides that
	selected using the control panel.
Printer driver setup	Click [Thick] in the [Type:] list.
Enabled paper feeding tray	Any input tray can be used.

		Note
		❒ Make sure paper is not stacked higher than the upper limit
		mark (T) inside the tray. Make sure paper is not stacked higher
		than the paper guides inside the bypass tray.
	Both-sided printing	Not possible
	Additional cautions	• Check the print side is facing up.
		• Check there is no air in the envelopes before loading.
		• For better print quality, we recommend the right, left, top, and
		bottom print margins to be at least 20 mm (0.8”) each.
		• Load only one size and type of envelope at a time.
		• Before loading envelopes, flatten their leading edges (the edge
		going into the printer) by running a pencil or ruler across
		them.
		• Some kinds of envelope might cause misfeeds, wrinkles or
		print poorly.
		• Print quality on envelopes may be uneven if parts of an enve-
		lope have differing thicknesses. Print one or two envelopes to
10		check print quality.