Before you start
Initial settings
When you power on the oven for the first time, the default time of “12:00” appears on the display where the hour element (“12”) blinks. Follow the steps below to set the current time.
1.With the hour element blinking, turn the
value dial
2.With the minute element blinking, turn
Smart safety mechanism
If you open the door while the oven is operating, the oven light turns on and both the fan and the heating elements stop operation. This is to prevent physical injuries such as burns as well as to prevent unnecessary energy loss. When this happens, simply close the door and the oven continues to operate normally because this is not a system failure.
Accessories
For first time use, clean the accessories thoroughly with warm water, detergent and a soft clean cloth.
Before you start
the value dial to set the minute, and then press OK.
To change the current time after this initial setting, hold down the 
button for 3 seconds and follow the above steps.
New oven smell
Before using the oven for the first time, clean inside the oven to remove the new oven smell.
1.Remove all accessories from inside the oven.
2.Run the oven with Convection 200 °C or Conventional 200 °C for an hour. This will burn any remaining production substances in the oven.
3.When complete, turn off the oven.
10 English
05
04
03
02
01
01 | Level 1 | 02 | Level 2 |
03 | Level 3 | 04 | Level 4 |
05Level 5
•Insert the accessory to the correct position inside of the oven.
•Allow at least a 1 cm space from the accessory and the bottom of the oven, and from any other accessory.
•Take caution in removing cookware and/ or accessories out of the oven. Hot meals or accessories can cause burns.
•The accessories may be deformed while they are gaining heat. Once they have cooled down, they will recover their original appearance and performance.
