EVENT
motion Detection
These settings are used to commence recording when motion is detected within a
1
4
6
8
1Video Display window
This window is used to defi ne the motion detec- tion zone for the selected video feed. Select the desired motion detection zone by dragging your mouse over the screen.
Set motion Detection Zone:
2Zone setting
Block Count: Use to designated the number of blocks in the motion detection zone grid.
Sensitivity: Use to select the sensitivity of motion detection.
Set All Area: Selects the whole screen for motion detection.
Erase All Area: Clears the screen of any motion blocks.
3Rec time
Pre rec time: Use to confi gure how long to record for leading up to a motion detection event.
Post rec time: Use to confi gure how long to record for following a motion detection event.
2
3
5
7
9
4Action Setting
Full Screen: Enable or disable full screen display of video feed when a motion event occurs.
Beep: Enable or disable the buzzer for events.
5Linked pTZ:
Camera: Use to associate a PTZ to the motion detection camera channel. When a motion detection event takes place, this feature moves the selected PTZ to a preset position.
Preset: Use to select the desired PTZ preset.
6Spot Full Up
Enable or disable full screen spot monitor pop up of the video feed when a motion event occurs. Dwell Time: Use to confi gure the duration for
displaying the camera on the spot port.
7Linked Camera
Link other cameras to record when the selected camera detects motion. Multiple cameras can be selected to be linked via motion.
8Apply to
The selected channel setting value can be applied to all or selected channels.
9Linked Alarm Out
Link Alarm Outs to trigger on motion detection in camera, multiple alarms can be linked via motion.
32_ System Setup
