Schneider Electric LXM32M First Setup, Switching on the device Power stage supply is switched off

5 Commissioning LXM32M

5.2"First Setup"

A "First Setup" is required when the controller supply is switched on for the first time or after the factory settings have been restored.

Switching on the device ■ The power stage supply is switched off.

▶Disconnect the product from the the fieldbus during commissioning in order to avoid conflicts by simultaneous access.

▶Switch on the controller supply.

◁The device goes through an initialization routine, all LEDs are tes- ted, all segments of the 7-segment display and the status LEDs light up.

After the initialization, the fieldbus interface must be configured. The product is configured via the integrated HMI or the commissioning software.

First Setup via HMI

Fault Edit Value Unit
Op
Mon
Conf
ESC				Fault Edit Value Unit
<1s				Op
				Mon
Fault Edit Value Unit	1.		2.	Conf
Op		<1s	ESC
Mon
Conf
	2 x		<1s

=

= =

IP

Subnet

Fault Edit Value Unit

Op

Mon

Conf

1.	2.
<1s	ESC

2 x <1s

1. 2. <1s ESC

2 x <1s

					Fault Edit Value Unit
Fault Edit Value Unit	Fault Edit Value Unit	1.		2.	Op
Op	Op		<1s	ESC	Mon
Mon	Mon				Conf
Conf	Conf
		2 x		<1s
					Fault Edit Value Unit
Fault Edit Value Unit	Fault Edit Value Unit	1.	2.		Op
Op	Op		<1s	ESC	Mon
Mon	Mon				Conf
Conf	Conf
		2 x	<1s

V1.01, 01.2012

Figure 6: First Setup via the integrated HMI

0198441113843,

38 Modbus-TCP module