Siemens E-110-I user manual Sub-Menus, Dsl

SIEMENS ADSL E-110_E-110-I user manual

Sub-Menus

For advanced mode, the following sub-menus are available:

Lan
LAN Config	Sets LAN configuration, which determines you the device is defined in the network.
DHCP Mode	Sets and configures the Dynamic Host Configuration Protocol mode for the device.
	With DHCP, IP addresses for your LAN are administrated and distributed as needed
	by this device or an ISP device.
DHCP Server	Lists the IP address pools available to computer on your LAN. The device distributes
	numbers in the pool to devices on your network as they request Internet access
	(refer to “Configuring DHCP Server”).
DHCP Relay	Lists each interface on the device that relays data from your ISP. As a DHCP relay
	agent, when a computer request Internet access, the device requests an IP address
	from your ISP, and then relays the addresses back to the computer (refer to
	“Configuring DHCP Relay”).
Wan
DSL	Displays configuration parameters and performance statistics for the ADSL Router’s
	DSL line (refer to “View DSL Parameters”).
ATM VC	Configures and displays an ATM virtual circuit (VC). The VC properties define the
	path that the ADSL Router uses to communicate with your ISP over the ATM
	network.
PPP	Configures and displays Point to Point Protocol (PPP) interfaces. The PPP protocol is
	commonly used between ISPs and their customers to identify and control various
	communication properties (refer to “PPP Connection Mode”).
EOA	Configures and displays RFC1483/Ethernet over ATM (EoA) interfaces. The EoA
	protocol is commonly used to carry data between LANs that use the Ethernet
	protocol and WANs that use the ATM protocol.
IPOA	Configures and displays IP over ATM (IPoA) interfaces. An IPoA interface can be
	used to exchange IP packets over ATM network, without using an underlying EoA
	connection (refer to “Router Connection Mode”).
Bridge
Bridging	Configures and displays Bridging information (refer also to “Bridge Mode”).
LAN Config	Sets LAN configuration, which determines you the device is defined in the network.
DSL	Displays configuration parameters and performance statistics for the ADSL Router’s
	DSL line (refer to “View DSL Parameters”).
ATM VC	Configures and displays an ATM virtual circuit (VC). The VC properties define the
	path that the ADSL Router uses to communicate with your ISP over the ATM network.
RFC 1483	Configures and displays RFC1483/Ethernet over ATM (EoA) interfaces. The EoA
Interface (EoA)	protocol is commonly used to carry data between LANs that use the Ethernet
	protocol and WANs that use the ATM protocol.
Routing
IP Route	Lists IP addresses of Internet destinations commonly accessed by your network.
	When a computer requests to send data to a listed destination, the device uses the
	Next Hop to identify the first Internet router it should contact to route the data most
	efficiently (refer to “Configuring IP Routes”).
IP Addr	Displays all IP addresses associated with ports on your device, including the LAN
	(Ethernet) port and the WAN (DSL).
LAN Config	Sets LAN configuration, which determines you the device is defined in the network.
DSL	Displays configuration parameters and performance statistics for the ADSL Router’s
	DSL line (refer to “View DSL Parameters”).
ATM VC	Configures and displays an ATM virtual circuit (VC). The VC properties define the
	path that the ADSL Router uses to communicate with your ISP over the ATM network.

38 Rev:01_040220