Each decoder adaptor can be installed in any input option slot.
Note
Turn off the main power of the monitor and disconnect the AC power cord before installing or removing adaptors.
1 Remove the cover of an input option slot on the rear panel of the monitor.
Cover of an input option slot
Make sure the MAIN POWER switch is turned OFF, and disconnect the AC power cord.
2 Insert the adaptor under the positioning mark on the top of the slot (on the left of the screw hole).
Positioning mark 
Insert the adaptor here. 
3 Push the adaptor in until it is firmly seated in the connector inside the monitor, then tighten the two screws to secure the adaptor.
Note
When installing a decoder adaptor in an input option slot on the rear of the monitor, or fitting a cover plate to an unused slot, always do such operation in order from the rightmost slot. If some adaptors are already installed, first of all remove them and then do the installing operation in order from the rightmost slot. When removing the adaptors, always loosen all adaptor screws and then remove the adaptors in order from the rightmost slot.
1 Chapter Overview
9