1MAIN POWER switch

When turned on, the monitor enters operation mode. By setting in the SYSTEM CONFIGURATION menu, the monitor can also be set to enter standby mode when the MAIN POWER switch is turned on.

Note

When the monitor is turned on, “INITIALIZING” is displayed. While it is displayed, the monitor cannot accept commands from the BKM-10R/11R Monitor Control Unit or the equipment connected to the serial REMOTE 1 connector.

For information about the SYSTEM CONFIGURATION menu, see “ [C4] Setting the Channel Selection Method, Power-Up Conditions and Decoder (SET UP 4) — SYSTEM CONFIGURATION Menu” on page 44.

2AC IN socket (3-pin)

Connects the monitor to an AC power source, via the supplied AC power cord.

AC power cord (supplied)

AC Plug holder (supplied)

Attach the AC Plug holder to the AC power cord, and connect it to the AC IN socket so that the cord does not come loose.

3Fuse

Use a T4AH fuse.

4Deflection option slot

For the BVM-D24E1WU/D24E1WE/D24E1WA/ D32E1WU/D32E1WE/D32E1WA, the digital uniformity adaptor has been installed at the factory. For the BVM-D20F1U/D20F1E/D20F1A, this slot is provided for future use.

5Analog input/output connectors

ANALOG

 

IN

 

Y/G

Y/G connectors (BNC)

OUT

 

IN

 

PB/B

PB/B connectors (BNC)

OUT

 

IN

 

PR/R

PR/R connectors (BNC)

OUT

 

IN

 

SYNC

SYNC connectors (BNC)

OUT

 

GBR signals, component signals (Y/PB/PR), or composite sync signals can be fed in the IN connectors. The type of signal applied to each connector is set with the INPUT CONFIGURATION menu. The OUT connectors are used for loop-through output of the input signal. When not using loop-through, connect a 75-ohm terminator (not supplied) to the OUT connectors.

For information about the INPUT CONFIGURATION menu, see “ [C1] Setting the Input Configuration (SET UP 1) — INPUT CONFIGURATION Menu” on page 35.

6Input option slots

The monitor may be fitted with optional decoder adaptors.

Note

The BKM-41HD and BKM-42HD use two input option slots.

(continued)

Overview 1 Chapter

13