[C721] SET PROBE ON CURSOR
To perform adjustment, operate the
(1)Place the
(2)Move the
In the same way, adjust each adjustment point guided by the cursor. When the adjustment of all the points is completed, the screen automatically returns to the WHITE UNIFORMITY menu (1/2) ([C7]).
To cancel the adjustment
Press the MENU button. The adjusted data is cleared and the screen returns to the WHITE UNIFORMITY menu (1/2) ([C7]).
If the
The following message appears, and the cursor moves to the right and left alternately on the screen.
DO YOU WISH TO ABORT?
LEFT CURSOR: ABORT
RIGHT CURSOR: CONTINUE
To abort, place the
To continue, place the
[C73] MANUAL menu
Adjust the gain of R, G and B with the MANUAL knobs.
The signal format and screen size for the adjustment are displayed on the top of the screen.
ADJUST... : Adjust the gain. ÷[C731] (It may take some time to change to the next menu.)
Use appropriate knobs and buttons in each adjustment as described below.
RED: CONTRAST KNOB: Adjust the R gain with the CONTRAST knob.
GREEN: BRIGHT KNOB: Adjust the G gain with the BRIGHT knob.
BLUE: CHROMA KNOB: Adjust the B gain with the CHROMA knob.
CURSOR POSITION: 10KEY: Move the cursor using the numeric keypad (except the 5 button) as illustrated below. Turn on/off the cursor using the 5 button.
The cursor moves in | 1 | 2 | 3 | |
|
|
| ||
the direction of the |
|
|
| |
arrow corresponding | 4 | 5 | 6 | |
to the pressed button. | ||||
|
|
| ||
| 7 | 8 | 9 |
CURSOR H SIZE: Specify the horizontal size of the cursor (1 to 4).
CURSOR V SIZE: Specify the vertical size of the cursor (1 to 4).
[C731] ADJUST menu
Adjust the gain at the cursor position using the CONTRAST (RED), BRIGHT (GREEN) and CHROMA (BLUE) knobs. Move the cursor using the numeric keypad.
To reset RED/GREEN/BLUE to the value before adjustment
When you are adjusting the gain using the MANUAL adjustment knobs, you can reset the setting to the one before adjustment by pressing the corresponding MANUAL button.
To cancel the adjustment
Press the MENU button. The adjusted data is cleared and the screen returns to [C73]. (It may take some time to change to the previous menu.)
When you want to erase characters from the screen while adjusting manually
Press the [F1] button. The characters disappear. To display characters, press the [F1] button again.
[C74] AUTO FULL POINTS menu
Before entering the AUTO FULL POINTS menu, connect the
SET PROBE ON CURSOR
[C741] SET PROBE ON CURSOR
To perform adjustment, operate the
(1)Place the
(2)Move the
Menu 2 Chapter
(continued) 53