[C6] Adjusting Geometry and Convergence (SET UP 6) — ALIGNMENT Menu

Menu 2 Chapter

Overview

The ALIGNMENT menu is used for adjusting geometry and convergence.

Note

Adjust the beam landing ([C8]) after the geometry and convergence adjustments have been completed.

The following adjustments can be performed with the three pages of the ALIGNMENT menu.

•Adjusting the position and size of the picture (ALIGNMENT menu (1/3))

•Adjusting the geometry of the picture (ALIGNMENT menu (2/3))

•Adjusting the convergence (ALIGNMENT menu (3/3))

Structure of the ALIGNMENT Menu

Level 1

Level 2

Level 3

Level 4

INPUT CONFIGURATION C1

REMOTE C2

PASSWORD C3

SYSTEM CONFIGURATION C4

ON SCREEN SET C5

ALIGNMENT

C6

 

 

 

ALIGNMENT (1/3) — ROTATION

 

 

 

 

 

 

 

WHITE UNIFORMITY

C7

 

 

 

 

 

 

 

ALIGNMENT (2/3) — H PIN

EXTEND MENU

C8

 

ALIGNMENT (3/3) — V STATIC CONV

1)

1)

CONV FINE ADJUST... C61 — ADJUST C611

1) BVM-D32E1WU/D32E1WE/D32E1WA only

Setting Lists of the ALIGNMENT Menu

This section explains the setting lists displayed in the menu.

How to read the setting lists

•For purposes of explanation, each setting list is preceded by a menu number. These numbers are not displayed on the screen.

For more information about the menu number, see “About menu numbers” on page 23.

•The arrow mark (÷) refers you to another setting list that appears after you make the setting, or to an operation that is carried out as a result of the setting. When there is no arrow mark, the menu does not have any sub-list.

48