2 Chapter Menu
[B1321] MONITOR ADDRESS menu
Select STD, COL1, COL2, or CH SET. ⎟ Copy is carried out.
STD: Copy common data (factory setting: D65).
COL1: Copy common data (factory setting: D93).
COL2: Copy common data (factory setting: D56/ D651)).
CH SET: Copy data from a particular channel. Enter the number of the channel from which the data will be copied.
[B133] MEMORY CARD menu Select the file name. ⎟ [B1331] FILE NAME: Select the file name.
Note
The input signal is not displayed during the data loading.
[B1331] FILE NAME menu
Select STD, COL1, COL2, or CH SET of the memory card data. ⎟ Copy is carried out.
STD: Copy common data (factory setting: D65).
COL1: Copy common data (factory setting: D93).
COL2: Copy common data (factory setting: D56/ D651)).
CH SET: Copy data from a particular channel. Enter the number of the channel from which the data will be copied.
[B14] TRIM menu
Finely adjust the gain and bias by selecting ADJUST. ADJUST: Adjust the gain and bias. To shift between gain adjustment and bias adjustment, press UP/ DOWN buttons. Use appropriate knobs in each
adjustment as described below. After the adjustment, press the ENTER or Ent button to confirm the adjusted values.
RED: CONTRAST KNOB (Adjust the R gain or bias with the CONTRAST knob.)
GREEN: BRIGHT KNOB (Adjust the G gain or bias with the BRIGHT knob.)
BLUE: CHROMA KNOB (Adjust the B gain or bias with the CHROMA knob.)
LUMINANCE: PHASE KNOB (Adjust luminance with the PHASE knob.)
To reset RED/GREEN/BLUE to the value before adjustment
When you are adjusting the gain or bias, you can reset the setting to the one before adjustment by pressing the corresponding MANUAL button.
To reset all of settings at the same time, press the PHASE button.
TRIM: Select whether to add the fine adjustment to the original setting (gain and bias set in MANUAL menu [B11]).
APPLY: Adds the fine adjustment to the original setting.
When APPLY is selected, “XX/TRIM” (XX: the selected color temperature among STD, COL 1 or COL 2) appears on the left top on the COLOR TEMP ADJ menu.
NOT APPLY: Reset the setting to the original setting (gain and bias set in MANUAL menu [B11]).
SIGNAL: Select the white signal to be used for adjustment.
INT: Use an internal signal. Simultaneously with the adjustment of the gain and bias, the 100 IRE and 20 IRE signals are automatically switched.
EXT: Use an external input signal. When adjusting the gain and bias, input the proper signal.
Note
Even if NOT APPLY of the TRIM item is selected, pressing the ENTER or Ent button to confirm the adjusted values results in that APPLY will be selected.
........................................................................................................................................................................................................
1)D56:
D65:
34